enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Plasma osmolality - Wikipedia

   en.wikipedia.org/wiki/Plasma_Osmolality

   Osmolarity is affected by changes in water content, as well as temperature and pressure. In contrast, osmolality is independent of temperature and pressure. For a given solution, osmolarity is slightly less than osmolality, because the total solvent weight (the divisor used for osmolality) excludes the weight of any solutes, whereas the total ...

3. Soil test - Wikipedia

   en.wikipedia.org/wiki/Soil_test

   In geotechnical engineering, a soil test can be used to determine the physical characteristics of a soil, such as its water content, void ratio or bulk density. Soil testing can also provide information related to the shear strength, rate of consolidation and permeability of the soil. The following is a non-exhaustive list of engineering soil ...

4. Osmol gap - Wikipedia

   en.wikipedia.org/wiki/Osmol_gap

   The osmol gap is typically calculated with the following formula (all values in mmol/L): = = ([+] + [] + []) In non-SI laboratory units: Calculated osmolality = 2 x [Na mmol/L] + [glucose mg/dL] / 18 + [BUN mg/dL] / 2.8 + [ethanol/3.7] [3] (note: the values 18 and 2.8 convert mg/dL into mmol/L; the molecular weight of ethanol is 46, but empiric data shows that it does not act as an ideal ...

5. Base-cation saturation ratio - Wikipedia

   en.wikipedia.org/wiki/Base-cation_saturation_ratio

   Base-cation saturation ratio (BCSR) is a method of interpreting soil test results that is widely used in sustainable agriculture, supported by the National Sustainable Agriculture Information Service (ATTRA) [1] and claimed to be successfully in use on over a million acres (4,000 km 2) of farmland worldwide.

6. Total dissolved solids - Wikipedia

   en.wikipedia.org/wiki/Total_dissolved_solids

   Total dissolved solids (TDS) is a measure of the dissolved combined content of all inorganic and organic substances present in a liquid in molecular, ionized, or micro-granular (colloidal sol) suspended form. TDS are often measured in parts per million (ppm). TDS in water can be measured using a digital meter. [1]

7. Intravenous iron infusion - Wikipedia

   en.wikipedia.org/wiki/Intravenous_Iron_Infusion

   Products such as Imferon, which contained high molecule weight iron dextran, were the only IV iron products available until the 1990s. [4] Although uncommon adverse reaction did occur, as such packaging informed users of the possible reactions and highly recommended completing a test dose before further treatment.

8. AOL Mail

   mail.aol.com

   Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

9. Vapor pressure osmometry - Wikipedia

   en.wikipedia.org/wiki/Vapor_pressure_osmometry

   This technique can be used for polymers with a molecular weight of up to 20,000 though accuracy is best for those below 10,000. [1] Although membrane osmometry is also based on the measurement of colligative properties , it has a lower bound of 25,000 for sample molecular weight that can be measured owing to problems with membrane permeation.