Search results
Results from the WOW.Com Content Network
Even though #14 and #16 screws are still available, they are not as common as sizes #0 through #12. [citation needed] Sometimes "special" diameter and pitch combinations (UNS) are used, for example a 0.619 in (15.7 mm) major diameter with 20 threads per inch. UNS threads are rarely used for bolts, but rather on nuts, tapped holes, and threaded ODs.
The size is imprinted on the spanners in millimeter values or inch sizes with intermediate sizes in fractions (older British and current US spanners). The two systems are in general not compatible, which can result in rounding of nuts and bolts (i.e. using a 13 mm (0.51 in) spanner in place of a 1 ⁄ 2 inch (12.70 mm)).
J-nut or U-nut, sheet metal nut, speed nut (ambiguously) Designed to be clipped to sheet metal Coupling nut: Extension nut A threaded fastener for joining two male threads, most commonly a threaded rod,[1][2] but also pipes Flange nut: Collar nut Has a wide flange at one end that acts as an integrated washer HARDLOCK Nut [3] Eccentric Double Nut
To simplify matters, the term hexagon is used in this section to denote either bolt head or nut. Two spanners, both nominal size 5 ⁄ 8 in, with a diagram superimposed to show the logic that allows them both to be nominal size 5 ⁄ 8 in when their actual sizes are clearly different (across-flats distance vs screw diameter). The across-flats ...
United States Standard thread (USS thread), also known as Sellers Standard thread, [1] Franklin Institute thread [1] and American Standard thread, [2] is a standard for inch based threaded fasteners and washers. [3] The USS standard is no longer supported. It, together with the SAE fastener standard, was incorporated into the Unified Thread ...
Below is a comprehensive drill and tap size chart for all drills and taps: Inch, imperial, and metric, up to 36.5 millimetres (1.44 in) in diameter. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.
British Standard Fine (BSF) is a screw thread form, as a fine-pitch alternative to British Standard Whitworth (BSW) thread. It was used for steel bolts and nuts on and in much of Britain's machinery, including cars, prior to adoption of Unified, and later Metric, standards.
A wingnut, wing nut or butterfly nut is a type of nut with two large metal "wings", one on each side, so it can be easily tightened and loosened by hand without tools. A similar fastener with a male thread is known as a wing screw [ 1 ] [ 2 ] or a wing bolt .