Search results
Results from the WOW.Com Content Network
By reducing the original signal rate to 1 ⁄ 4 or 1 ⁄ 2, the link speed drops to 2.5 or 5 Gbit/s, respectively. [5] The spectral bandwidth of the signal is reduced accordingly, lowering the requirements on the cabling, so that 2.5GBASE-T and 5GBASE-T can be deployed at a cable length of up to 100 m on Cat 5e or better cables. [6] [7]
DIMM modules connect to the computer via a 64-bit-wide interface. Some other computer architectures use different modules with a different bus width. In a single-channel configuration, only one module at a time can transfer information to the CPU.
The physical-layer specifications of the Ethernet family of computer network standards are published by the Institute of Electrical and Electronics Engineers (IEEE), which defines the electrical or optical properties and the transfer speed of the physical connection between a device and the network or between network devices.
A standardized variant of 10 Gigabit Ethernet, called WAN PHY, is designed to inter-operate with OC-192 transport equipment while the common version of 10 Gigabit Ethernet is called LAN PHY (which is not compatible with OC-192 transport equipment in its native form). The naming is somewhat misleading, because both variants can be used on a wide ...
IEEE 802.3 is a working group and a collection of standards defining the physical layer and data link layer's media access control (MAC) of wired Ethernet.The standards are produced by the working group of the Institute of Electrical and Electronics Engineers (IEEE).
Cross section of a cat 5e cable. The Category 5e specification improves upon the Category 5 specification by further mitigating crosstalk. [9] The bandwidth (100 MHz) and physical construction are the same between the two, [10] and most Cat 5 cables actually happen to meet Cat 5e specifications even though they are not certified as such. [11]
ANSI/TIA-568 is a technical standard for commercial building cabling for telecommunications products and services. The title of the standard is Commercial Building Telecommunications Cabling Standard and is published by the Telecommunications Industry Association (TIA), a body accredited by the American National Standards Institute (ANSI).
Each 1000BASE-T network segment is recommended to be a maximum length of 100 meters (330 feet), [5] [a] and must use Category 5 cable or better (including Cat 5e and Cat 6). Autonegotiation is a requirement for using 1000BASE-T [6] according to Section 28D.5 Extensions required for Clause40 (1000BASE-T). [7]