Search results
Results from the WOW.Com Content Network
The moisture content of grains is an essential property in food storage. The moisture content that is safe for long-term storage is 12% for corn, sorghum, rice and wheat and 11% for soybean [ 1 ] At a constant relative humidity of air, the EMC will drop by about 0.5% for every increase of 10 °C air temperature.
This relationship between water activity and moisture content at a given temperature is called the moisture sorption isotherm. These curves are determined experimentally and constitute the fingerprint of a food system. [2] BET theory (Brunauer-Emmett-Teller) provides a calculation to describe the physical adsorption of gas molecules on a solid ...
In food science, water activity (a w) of a food is the ratio of its vapor pressure to the vapor pressure of water at the same temperature, both taken at equilibrium. [1] Pure water has a water activity of one. Put another way, a w is the equilibrium relative humidity (ERH) expressed as a fraction instead of as a percentage.
The path or series of states through which a system passes from an initial equilibrium state to a final equilibrium state [1] and can be viewed graphically on a pressure-volume (P-V), pressure-temperature (P-T), and temperature-entropy (T-s) diagrams. [2] There are an infinite number of possible paths from an initial point to an end point in a ...
Related: 11 Freezer Storage Mistakes That Are Ruining Your Frozen Food. The Safe Zone. The correct temperature for your freezer is 0 degrees Fahrenheit—if you set it to 0 degrees (-18 degrees ...
The saturation with respect to water cannot be measured much below –50 °C, so manufacturers should use one of the following expressions for calculating saturation vapour pressure relative to water at the lowest temperatures – Wexler (1976, 1977), [1] [2] reported by Flatau et al. (1992)., [3] Hyland and Wexler (1983) or Sonntag (1994 ...
The wet-bulb temperature is the lowest temperature that may be achieved by evaporative cooling of a water-wetted, ventilated surface.. By contrast, the dew point is the temperature to which the ambient air must be cooled to reach 100% relative humidity assuming there is no further evaporation into the air; it is the temperature where condensation (dew) and clouds would form.
To compute the VPD, [2] we need the ambient (greenhouse) air temperature, the relative humidity and, if possible, the canopy air temperature. We must then compute the saturation pressure. Saturation pressure can be looked up in a psychrometric chart or derived from the Arrhenius equation; a way to compute it directly from temperature is