Search results
Results from the WOW.Com Content Network
Small impulse sealer Heat-sealed material lies on a warehouse floor. Notice the corded heat sealer to the left. Heat sealer used to prepare plastic bag of lettuce for shelf life testing Continuous band heat sealer. A heat sealer is a machine used to seal products, packaging, and other thermoplastic materials using heat. This can be with uniform ...
A seal is a device or material that helps join systems, mechanisms or other materials together by preventing leakage (e.g. in a pumping system), containing pressure, or excluding contamination. The effectiveness of a seal is dependent on adhesion in the case of sealants and compression in the case of gaskets .
In mechanical engineering, an end-face mechanical seal (often shortened to mechanical seal) is a type of seal used in rotating equipment, such as pumps, mixers, blowers, and compressors. When a pump operates, the liquid could leak out of the pump between the rotating shaft and the stationary pump casing. Since the shaft rotates, preventing this ...
A plate heat exchanger is a type of heat exchanger that uses metal plates to transfer heat between two fluids.This has a major advantage over a conventional heat exchanger in that the fluids are exposed to a much larger surface area because the fluids are spread out over the plates.
Abrasion resistant steel undergoes a two-step heat treatment process called quenching and tempering, which alters the steel's grain structure to increase hardness and toughness. [ 2 ] During the quenching phase, the steel is heated to an above-critical temperature and is then rapidly cooled with water.
There are two types of continuous cooling diagrams drawn for practical purposes. Type 1: This is the plot beginning with the transformation start point, cooling with a specific transformation fraction and ending with a transformation finish temperature for all products against transformation time for each cooling curve.
The white opaque "glue" between the panel and the funnel of a colour TV cathode ray tube is a devitrified solder glass based on the system PbO – ZnO – B 2 O 3.While this is a glass-ceramic-to-glass seal, the basic patent of S.A. Claypoole considers glass-ceramic-to-metal seals as well.
These resistors are designed to withstand unusually high temperatures of up to 450 °C. [3] Wire leads in low power wirewound resistors are usually between 0.6 and 0.8 mm in diameter and tinned for ease of soldering. For higher power wire-wound resistors, either a ceramic outer case or an aluminum outer case on top of an insulating layer is used.