Search results
Results from the WOW.Com Content Network
FTDI US232R : USB to RS-232 cable. A USB-to-serial adapter or simply USB adapter is a type of protocol converter that is used for converting USB data signals to and from serial communications standards (serial ports). Most commonly the USB data signals are converted to either RS-232, RS-485, RS-422, or TTL-level UART serial data.
Adapters and cables with a USB-C receptacle are not allowed. [31] Full-featured USB-C 3.1 cables contain a full set of wires and are "electronically marked" : they contain a "eMarker" chip that responds to the USB Power Delivery Discover Identity command, a kind of vendor-defined message (VDM) sent over the configuration data channel (CC ...
The FME female is designed to be low diameter to allow cables it has been installed on to be snaked through the often tight access holes or spaces of a vehicle to the desired equipment location(s) where an FME male adapter to the required equipment connector series is fitted to the female cable connector. The thread is 8mm*0.75mm pitch, and the ...
Fibre Channel host bus adapter. The term host bus adapter (HBA) may be used to refer to a Fibre Channel interface card. In this case, it allows devices in a Fibre Channel storage area network to communicate data between each other – it may connect a server to a switch or storage device, connect multiple storage systems, or connect multiple servers. [2]
The new Blue&Me system debuted on the Alfa Romeo 159, Alfa Romeo Brera, and Fiat Grande Punto, which were shown at the 2006 Geneva Motor Show. [5] By 2007, Fiat were reporting that 20% of customers were requesting Blue&Me, and had announced an integrated navigation system, Blue&Me Nav. [ 6 ]
W-USB interacts with wired USB via wire adapters. W-USB can form true USB systems, formed by a host, devices and interconnection support. It implements the USB hub–spoke model, in which up to 127 wireless devices can form point-to-point links (spokes) with the host (the hub). The host controller is unique in the system and is usually embedded ...
Apple Lightning to USB-A cable. Lightning is an 8-pin digital connector. Unlike the 30-pin dock connector it replaced (and USB Type-A and -B connectors), it is reversible. [23] Most Lightning devices only support USB 2.0, which has a maximum transfer speed of 480 Mbit/s or 60 MB/s. With USB 2.0, only one lane is in use at a time.
A double DIN 1.6/5.6 bulkhead jack connector, crimp type, for 75 Ω coaxial cable A Type N connector (male), right-angled solder-type for semi-rigid coaxial cable with a diameter of 0.141-inch. 4.1-9.5 connector, standardized as DIN 47231 (in 1974) and IEC 60169-11 (in 1977) 4.3-10 connector, formerly known as DIN 4.3/10, now standardized as ...