Search results
Results from the WOW.Com Content Network
Basic aircraft control surfaces and motion. A)aileron B)control stick C)elevator D)rudder. Aircraft flight control surfaces are aerodynamic devices allowing a pilot to adjust and control the aircraft's flight attitude. Development of an effective set of flight control surfaces was a critical advance in the development of aircraft.
Cockpit controls and instrument panel of a Cessna 182D Skylane. Generally, the primary cockpit flight controls are arranged as follows: [2] A control yoke (also known as a control column), centre stick or side-stick (the latter two also colloquially known as a control or joystick), governs the aircraft's roll and pitch by moving the ailerons (or activating wing warping on some very early ...
An aircraft 'rolling', or 'banking', with its ailerons An aileron and roll trim tab of a light aircraft. An aileron (French for "little wing" or "fin") is a hinged flight control surface usually forming part of the trailing edge of each wing of a fixed-wing aircraft. [1]
Another aircraft with full-length double-slotted flaps was the Wren 460. To go with large aileron deflections at low speeds [5] it had a set of five feathering drag plates ahead of each aileron to overcome adverse aileron yaw and decrease lift on the low wing. [6] Boeing's line of jet airliners have flight spoilers which can act as roll ...
The aileron roll is commonly executed through the application of full aileron in one direction. In some lower powered general aviation and aerobatic training aircraft, prior to applying aileron input, the pilot must begin the maneuver by trading altitude for airspeed (i.e. diving). This helps achieve enough airspeed to complete the roll without ...
Aircraft flight mechanics are relevant to fixed wing (gliders, aeroplanes) and rotary wing (helicopters) aircraft. An aeroplane ( airplane in US usage), is defined in ICAO Document 9110 as, "a power-driven heavier than air aircraft, deriving its lift chiefly from aerodynamic reactions on surface which remain fixed under given conditions of flight".
The deceleron, or split aileron, was developed in the late 1940s by Northrop, originally for use on the F-89 Scorpion fighter. It is a two-part aileron that can be deflected as a unit to provide roll control, or split open to act as an air brake .
The slow roll appears similar to the aileron roll, except the roll rate is typically slower, and both the aircraft attitude and altitude are held consistent throughout the maneuver. The slow roll produces a constantly shifting load of one g-force on both the pilot and the aircraft, from one g positive in the upright position to one g negative ...