Search results
Results from the WOW.Com Content Network
Below 912 °C (1,674 °F), iron has a body-centered cubic (bcc) crystal structure and is known as α-iron or ferrite.It is thermodynamically stable and a fairly soft metal. α-Fe can be subjected to pressures up to ca. 15 GPa before transforming into a high-pressure form termed ε-Fe discussed below.
English: Molar volume as function of pressure for alpha-iron at room temperature. Experimental data (N=95) are from Basinski et al. (1955, Proc. R. Soc. Experimental data (N=95) are from Basinski et al. (1955, Proc. R. Soc.
The ideal gas equation can be rearranged to give an expression for the molar volume of an ideal gas: = = Hence, for a given temperature and pressure, the molar volume is the same for all ideal gases and is based on the gas constant: R = 8.314 462 618 153 24 m 3 ⋅Pa⋅K −1 ⋅mol −1, or about 8.205 736 608 095 96 × 10 −5 m 3 ⋅atm⋅K ...
Molar volume vs. pressure for α iron at room temperature ... (14 alpha particles) is ... The ferrous halides typically arise from treating iron metal with the ...
The following molar volumes and densities for the majority of the gaseous elements were calculated from the van der Waals equation of state, using the quoted values of the van der Waals constants. The source for the van der Waals constants and for the literature densities was: R. C. Weast (Ed.), Handbook of Chemistry and Physics (53rd Edn ...
Note that the especially high molar values, as for paraffin, gasoline, water and ammonia, result from calculating specific heats in terms of moles of molecules. If specific heat is expressed per mole of atoms for these substances, none of the constant-volume values exceed, to any large extent, the theoretical Dulong–Petit limit of 25 J⋅mol ...
This page was last edited on 16 November 2024, at 12:16 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may apply.
In chemistry, the lever rule is a formula used to determine the mole fraction (x i) or the mass fraction (w i) of each phase of a binary equilibrium phase diagram.It can be used to determine the fraction of liquid and solid phases for a given binary composition and temperature that is between the liquidus and solidus line.