Search results
Results from the WOW.Com Content Network
Herbert Hill pushed his team to make continuous improvements to the basic Rzeppa constant velocity joint and was rewarded in the 1960s when much of the world's motor industry switched to front wheel drive using Birfield joints, the CV joints now made by GKN Driveline and currently installed in more than one-third of all new cars worldwide. [4]
A roller bearing between the axle hub and axle shaft ensures easy rotation of the non-drive wheels. On the axle side, it is mounted to the holding bracket from the chassis; on the disc side, the wheel is mounted to the bolts of the WHA. When replacing, a wheel hub assembly should be torqued to the vehicle's specifications to prevent failure. [1]
The A-series are 2- to 10-speed automatic transmissions for front wheel drive, all wheel drive, or rear wheel drive use built by Aisin-Warner. Models: Axx RWD 2-, 3-, and 4-speed; A1xx FWD 3- and 4-speed; A2xx FWD 4-speed; A3xx RWD/4WD truck; A4xx RWD/4WD truck; A5xx FWD; A6xx RWD/4WD 5-speed; A7xx RWD/AWD/4WD truck; A8xx; A9xx RWD; AAxx RWD ...
Splines on a front drive axle. An axle that is driven by the engine or prime mover is called a drive axle. Modern front-wheel drive cars typically combine the transmission (gearbox and differential) and front axle into a single unit called a transaxle. The drive axle is a split axle with a differential and universal joints between the two half ...
Unlike a kingpin, which requires an assembly in the center of the wheel in order to pivot, joints connect to the upper and lower end of the spindle (steering knuckle), to the control arms. This leaves the center section open to allow the use of front-wheel drive. Older kingpin designs can only be used in a rear-wheel-drive configuration.
Locking hubs, also known as free wheeling hubs are fitted to some (mainly older) four-wheel drive vehicles, allowing the front wheels to rotate freely when disconnected (unlocked) from the front axle. This is done to reduce the mechanical resistance of the front-portion of the drivetrain when four-wheel drive is not in use. [1]
Individual pivot points for the beams at greater than center made each beam longer than half the overall width crossing in the middle. This allowed for an independent front suspension design. Ford TTB Dana 44 axles all utilized locking hubs. The TTB set-up is based on Ford's highly successful Twin I-beam design on two-wheel-drive pick-up truck ...
A front-engine, rear-wheel-drive layout (FR), also called Systeme Panhard [1] is a powertrain layout with an engine in front and rear-wheel-drive, connected via a drive shaft. This arrangement, with the engine straddling the front axle, was the traditional automobile layout for most of the pre-1950s automotive mechanical projects. [2]