Ad
related to: what are ceiling beams called
Search results
Results from the WOW.Com Content Network
Vigas are wooden beams used in the traditional adobe architecture of the American Southwest, especially in New Mexico.In this type of construction, the vigas are the main structural members carrying the weight of the roof to the load-bearing exterior walls.
A ceiling can also be the upper limit of a tunnel. The most common type of ceiling is the dropped ceiling, [citation needed] which is suspended from structural elements above. Panels of drywall are fastened either directly to the ceiling joists or to a few layers of moisture-proof plywood which are then attached to the joists. Pipework or ducts ...
A girder or main "summer beam" of a floor: if supported on two storey posts and open below, also called a "bress" or "breast-summer". Often found at the centerline of the house to support one end of a joist, and to bear the weight of the structure above. [83] Spandrel 1.
Historically a beam is a squared timber, but may also be made of metal, stone, or a combination of wood and metal [1] such as a flitch beam.Beams primarily carry vertical gravitational forces, but they are also used to carry horizontal loads such as those due to earthquake or wind, or in tension to resist rafter thrust or compression (collar beam).
A purlin plate in wood construction is also called an "arcade plate" in European English, [1] "under purlin", and "principal purlin". The term plate means a major, horizontal, supporting timber. Purlin plates are beams which support the mid-span of rafters and are supported by posts. By supporting the rafters they allow longer spans than the ...
The term binding joist is sometimes used to describe beams at floor level running perpendicular to the ridge of a gable roof and joined to the intermediate posts. Joists which land on a binding joist are called bridging joists. [4] [5] A large beam in the ceiling of a room carrying joists is a summer beam. A ceiling joist may be installed flush ...
I-beams are still available in US sizes from many Canadian manufacturers. In Mexico, steel I-beams are called IR and commonly specified using the depth and weight of the beam in metric terms. For example, a "IR250x33" beam is approximately 250 mm (9.8 in) in depth (height of the I-beam from the outer face of one flange to the outer face of the ...
The simplest form of roof framing is a common rafter roof. This roof framing has nothing but rafters and a tie beam at the bottoms of the rafters. The next step in the development of roof framing was to add a collar, called a collar beam roof. Collar beam roofs are suitable for spans up to around (4.5 meters). [5]
Ad
related to: what are ceiling beams called