Search results
Results from the WOW.Com Content Network
Some operating systems, notably Windows Vista, Windows 7, Windows 8, Windows 8.1 and Windows 10, do not configure themselves to load the AHCI driver upon boot if the SATA controller was not in AHCI mode at the time the operating system was installed. Although this is an easily rectifiable condition, it remains an ongoing issue with the AHCI ...
Several Parallel ATA hard disk drives. Parallel ATA, originally IDE and then standardized under the name AT Attachment (ATA), with the alias P-ATA or PATA retroactively added upon introduction of the new variant Serial ATA. The original name (circa 1986) reflected the integration of the controller with the hard drive itself.
Both set were available US$60 for 10 MHz version and US$90 for 12 MHz version in quantities of 100. [2] This chipset can be used with an 82335 High-integration Interface Device to provide support for the Intel 386SX. [3] [4] List of early Intel chipset includes: [5] [6] 82077AA CHMOS Single-Chip Floppy Disk Controller for the 32-bit systems. [7 ...
The most recent ATA standard, ATA-8, was published in 2004. [17] It has undergone regular revisions, [ 18 ] the latest being in 2011. [ 19 ] Standardization of similar features on SCSI is more scarce and is not named as such on standards, although vendors and consumers alike do refer to these similar features as S.M.A.R.T. too. [ 20 ]
v14.10.0.1016: February 2016: Last version to support PCH 8 & 9 series v15.x.x.x: 2016: v15.9.8.1050: July 2020: Last version to support Windows 8.1 and earlier. Last version to support Smart Response cache acceleration with a SATA SSD. [27] Recommended for PCH 100/200 series in AHCI mode [26] v16.0.2.1086: February 2018: First generic version ...
Fibre Channel host bus adapter. The term host bus adapter (HBA) may be used to refer to a Fibre Channel interface card. In this case, it allows devices in a Fibre Channel storage area network to communicate data between each other – it may connect a server to a switch or storage device, connect multiple storage systems, or connect multiple servers. [2]
When enabled via the AHCI controller, this allows the SATA host bus adapter to enter a low-power state during periods of inactivity, thus saving energy. The drawback to this is increased periodic latency as the drive must be re-activated and brought back on-line before it can be used, and this will often appear as a delay to the end-user.
SCSI / ATA Translation (SAT) is a set of standards developed by the T10 subcommittee, defining how to communicate with ATA devices through a SCSI application layer. The standard attempts to be consistent with the SCSI architectural model , the SCSI Primary Commands, and the SCSI Block Commands standards.