Search results
Results from the WOW.Com Content Network
Some operating systems, notably Windows Vista, Windows 7, Windows 8, Windows 8.1 and Windows 10, do not configure themselves to load the AHCI driver upon boot if the SATA controller was not in AHCI mode at the time the operating system was installed. Although this is an easily rectifiable condition, it remains an ongoing issue with the AHCI ...
When enabled via the AHCI controller, this allows the SATA host bus adapter to enter a low-power state during periods of inactivity, thus saving energy. The drawback to this is increased periodic latency as the drive must be re-activated and brought back on-line before it can be used, and this will often appear as a delay to the end-user.
Several Parallel ATA hard disk drives. Parallel ATA, originally IDE and then standardized under the name AT Attachment (ATA), with the alias P-ATA or PATA retroactively added upon introduction of the new variant Serial ATA. The original name (circa 1986) reflected the integration of the controller with the hard drive itself.
The most recent ATA standard, ATA-8, was published in 2004. [17] It has undergone regular revisions, [ 18 ] the latest being in 2011. [ 19 ] Standardization of similar features on SCSI is more scarce and is not named as such on standards, although vendors and consumers alike do refer to these similar features as S.M.A.R.T. too. [ 20 ]
The "It's now safe to power off the system" screen in Windows 10 and 11. Microsoft's Windows 98 was the first operating system to implement ACPI, [ 17 ] [ 18 ] but its implementation was somewhat buggy or incomplete, [ 19 ] [ 20 ] although some of the problems associated with it were caused by the first-generation ACPI hardware. [ 21 ]
Up to version 4 it is included on Intel Application Accelerator RAID Edition, [2] between versions 5 and 8.9 it is included on Intel Matrix Storage Manager (IMSM), since version 9 it is included on Intel Rapid Storage Technology (IRST) preferring the driver modes to be named RST AHCI and RST AHCI RAID instead of Matrix RAID.
[4] [5] Linux kernels support AHCI natively since version 2.6.19, and FreeBSD fully supports AHCI since version 8.0. Windows Vista and Windows 7 also natively support AHCI, but their AHCI support (via the msahci service) must be manually enabled via registry editing if controller support was not present during their initial install.
In SAS, both SCSI port identifiers and SCSI device names take the form of a SAS address, which is a 64 bit value, normally in the NAA IEEE Registered format. People sometimes refer to a SCSI port identifier as the SAS address of a device, out of confusion. People sometimes call a SAS address a World Wide Name or WWN, because it is essentially ...