Search results
Results from the WOW.Com Content Network
A second display or second displays is a common term describing the multi-monitor setup with just one additional monitor attached. Today it is particularly common to have one workstation with two monitors connected where the second monitor is referred to as the second display. Many tablets will serve as a second display connected to a laptop. [22]
The signal standard and pinout are backward-compatible with CGA, allowing EGA monitors to be used on CGA cards and vice versa. Early VGA cards also used this connector. VGA connector (DE-15) Became a nearly ubiquitous analog computer display connector after first being introduced with IBM x86 machines. Older VGA connectors were DE-9 (9-pin).
Prior to the DDC, the VGA standard had reserved four pins in the analog VGA connector, known as ID0, ID1, ID2 and ID3 (pins 11, 12, 4 and 15) for identification of monitor type. These ID pins, attached to resistors to pull one or more of them to ground (GND), allowed for the definition of the monitor type, with all open (n/c, not connected ...
The Video Graphics Array (VGA) connector is a standard connector used for computer video output. Originating with the 1987 IBM PS/2 and its VGA graphics system, the 15-pin connector went on to become ubiquitous on PCs, [1] as well as many monitors, projectors and HD television sets.
The data is transmitted via the cable connecting the display and the graphics card; VGA, DVI, DisplayPort and HDMI are supported. [citation needed] The EDID is often stored in the monitor in the firmware chip called serial EEPROM (electrically erasable programmable read-only memory) and is accessible via the I²C-bus at address 0x50. The EDID ...
Carries standard definition video and does not carry audio on the same cable. Mini-DIN 4-pin Component. In popular use, it refers to a type of analog video information that is transmitted or stored as three separate signals. Either RGB interfaces or YPbPr: 3 RCA jacks: Composite, S-Video, and Component: VIVO = Mini-DIN 9-pin with breakout cable.
A composite monitor or composite video monitor is any analog video display that receives input in the form of an analog composite video signal to a defined specification. [1] A composite video signal encodes all information on a single conductor; a composite cable has a single live conductor plus earth.
The motivation for including analog is to keep compatibility with the previous VGA cables and connectors. VGA pins for HSync, Vsync and three video channels are available in both DVI-I or DVI-A (but not DVI-D) connectors and are electrically compatible, while pins for DDC (clock and data) and 5 V power and ground are kept in all DVI connectors ...