Search results
Results from the WOW.Com Content Network
A McCabe–Thiele diagram for the distillation of a binary (two-component) feed is constructed using the vapor-liquid equilibrium (VLE) data—which is how vapor is concentrated when in contact with its liquid form—for the component with the lower boiling point. Figure 1: Typical McCabe–Thiele diagram for distillation of a binary feed
[1] [2] Fractions are collected based on differences in a specific property of the individual components. A common trait in fractionations is the need to find an optimum between the amount of fractions collected and the desired purity in each fraction. Fractionation makes it possible to isolate more than two components in a mixture in a single run.
Fractional distillation in a laboratory makes use of common laboratory glassware and apparatuses, typically including a Bunsen burner, a round-bottomed flask and a condenser, as well as the single-purpose fractionating column. Fractional distillation. As an example, consider the distillation of a mixture of water and ethanol. Ethanol boils at ...
Key fractional distillation concepts: theoretical stages, x-y diagrams, multicomponent distillation, column composition and temperature profiles; Process design and optimization: minimum reflux and minimum stages, optimum reflux, short-cut methods, feed entry location
Fractionation at total reflux. The Fenske equation in continuous fractional distillation is an equation used for calculating the minimum number of theoretical plates required for the separation of a binary feed stream by a fractionation column that is being operated at total reflux (i.e., which means that no overhead product distillate is being withdrawn from the column).
Saddle: These are pure components or azeotropic points with an intermediate boiling temperature and vapor pressure in a distillation region. Residue curves move toward and then away from saddles but saddles are never end points. Only border lines start or end at saddles. The distillation regions and the nodes are the topology of the mixture.
The newly formed vapor can then be discarded or condensed into a separate container. When the vapors are collected, this process is known as distillation. [6] The process of petroleum refinement utilizes a technique known as fractional distillation, which allows several chemicals of varying volatility to be separated in a single step.
The condensate is usually withdrawn intermittently having products or cuts of different concentrations. Batch distillation is used when the feed rate is not large enough to justify installation of a continuous distillation unit. It may also be used when the constituents greatly differ in volatility. [8] [9] Figure 1 show the batch distillation ...