Search results
Results from the WOW.Com Content Network
A Davies condenser, also known as a double surface condenser, is similar to the Liebig condenser, but with three concentric glass tubes instead of two. The coolant circulates in both the outer jacket and the central tube. This increases the cooling surface, so that the condenser can be shorter than an equivalent Liebig condenser.
Liebig condenser. The Liebig condenser (/ ˈ l iː b ɪ ɡ /, LEE-big) [1] or straight condenser is a piece of laboratory equipment, specifically a condenser consisting of a straight glass tube surrounded by a water jacket. In typical laboratory operation, such as distillation, the condenser is clamped to a retort stand in vertical
The Liebig condenser is simply a straight tube within a cooling water jacket and is the simplest (and relatively least expensive) form of condenser. The Graham condenser is a spiral tube within a water jacket, and the Allihn condenser has a series of large and small constrictions on the inside tube, each increasing the surface area upon which ...
The Liebig condenser is simply a straight tube within a water jacket and is the simplest (and relatively least expensive) form of condenser. The Graham condenser is a spiral tube within a water jacket, and the Allihn condenser has a series of large and small constrictions on the inside tube, each increasing the surface area upon which the vapor ...
Stages 4→1: Low pressure wet steam leaving the turbine is condensed in the (condenser. A high vacuum in the condenser improves efficiency. In the practical implementation of a Rankine cycle, it is common to break the pump process (stages 1→2) into three pumps: (in water flow order: condensate pump, feed booster pump and then feedwater pump).
Vacuum technology is based on differential air pressure. Rotary vane vacuum pumps generate an operation pressure of -0.4 to -0.6 bar at the vacuum station, which is also the only element of the vacuum sewerage system that must be supplied with electricity. Interface valves are installed inside the collection chambers. They work pneumatically.
A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.
A rupture disc (burst) Pressure-effect acting at a rupture disc A rupture disc, also known as a pressure safety disc, burst disc, bursting disc, or burst diaphragm, is a non-reclosing pressure relief safety device that, in most uses, protects a pressure vessel, equipment or system from overpressurization or potentially damaging vacuum conditions.