Search results
Results from the WOW.Com Content Network
Frequency mixer symbol. In electronics, a mixer, or frequency mixer, is an electrical circuit that creates new frequencies from two signals applied to it.In its most common application, two signals are applied to a mixer, and it produces new signals at the sum and difference of the original frequencies.
Such circuits are widely used for frequency conversion in radio systems. [1] The advantage of this circuit is the output current is an accurate multiplication of the (differential) base currents of both inputs. As a mixer, its balanced operation cancels out many unwanted mixing products, resulting in a "cleaner" output.
A simple mixer will pass both of the input frequencies and all of their harmonics along with the sum and difference frequencies. If the simple mixer is replaced with a balanced mixer then the number of possible products is reduced. If the frequency mixer has fewer outputs the task of making sure that the final output is clean will be simpler.
Circuit symbol of a heptode. The development of the pentagrid or heptode (seven-electrode) valve was a novel development in the mixer story. The idea was to produce a single valve that not only mixed the oscillator signal and the received signal and produced its own oscillator signal at the same time but, importantly, did the mixing and the oscillating in different parts of the same valve.
Block diagram of a superheterodyne receiver. The RF front end consists of the components on the left colored red. In a radio receiver circuit, the RF front end, short for radio frequency front end, is a generic term for all the circuitry between a receiver's antenna input up to and including the mixer stage. [1]
A 5-tube superheterodyne receiver manufactured by Toshiba circa 1955 Superheterodyne transistor radio circuit circa 1975. A superheterodyne receiver, often shortened to superhet, is a type of radio receiver that uses frequency mixing to convert a received signal to a fixed intermediate frequency (IF) which can be more conveniently processed than the original carrier frequency.
A schematic of a superhet AM receiver. Note that the radio includes an AGC loop in order to maintain the RF and IF stages in their linear region, and to produce an audio output not dependent on the signal power received. Here we show block diagrams for typical superheterodyne receivers for AM and FM broadcast respectively.
RF microwave CAE CAD is computer-aided design (CAD) using computer technology to aid in the design, modeling, and simulation of an RF (Radio Frequency) or microwave product. [ 1 ] [ 2 ] It is a visual and symbol-based method of communication whose conventions are particular to RF/microwave engineering.