Search results
Results from the WOW.Com Content Network
There are two types of violation that can be caused by clock skew. One problem is caused when the clock reaches the first register and the clock signal towards the second register travels slower than output of the first register into the second register - the output of the first register reaches the second register input faster and therefore is clocked replacing the initial data on the second ...
Jitter period is the interval between two times of maximum effect (or minimum effect) of a signal characteristic that varies regularly with time. Jitter frequency, the more commonly quoted figure, is its inverse. ITU-T G.810 classifies deviation lower frequencies below 10 Hz as wander and higher frequencies at or above 10 Hz as jitter. [2]
This involves comparing the timer tick of the operating system (the tick that usually is 100–1000 times per second) and the speed of the CPU. If the OS timer and the CPU run on two independent clock crystals the situation is ideal and more or less the same as the previous example.
Instantaneous packet delay variation is the difference between successive packets—here RFC 3393 does specify the selection criteria—and this is usually what is loosely termed "jitter", although jitter is also sometimes the term used for the variance of the packet delay. As an example, say packets are transmitted every 20 ms.
Jitter is the undesired deviation from true periodicity of an assumed periodic signal in electronics and telecommunications, often in relation to a reference clock source. Jitter may be observed in characteristics such as the frequency of successive pulses, the signal amplitude , or phase of periodic signals.
When UI is used as a measurement unit of a time interval, the resulting measure of such time interval is dimensionless. It expresses the time interval in terms of UI. Very often, but not always, the UI coincides with the bit time, i.e. with the time interval taken to transmit one bit (binary information digit).
PPS signals are used for precise timekeeping and time measurement. One increasingly common use is in computer timekeeping, including NTP.Because GPS is considered a stratum-0 source, a common use for the PPS signal is to connect it to a PC using a low-latency, low-jitter wire connection and allow a program to synchronize to it.
Most frequency counters work by using a counter, which accumulates the number of events occurring within a specific period of time.After a preset period known as the gate time (1 second, for example), the value in the counter is transferred to a display, and the counter is reset to zero.