enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. AMC and Jeep transmissions - Wikipedia

   en.wikipedia.org/wiki/AMC_and_Jeep_transmissions

   The Dana 20 is generally compatible with the "big hole" Dana 18. One exception is the version used with the THM400 in full-size Jeep trucks, which used a different spline number on the input gear. Applications: Jeep CJ; Jeep SJ; 1963-1979 Willys-Overland Jeepster; 1979 International Scout with 727TF AT uses the 23 spline 26 tooth gear.

3. Dana 44 - Wikipedia

   en.wikipedia.org/wiki/Dana_44

   In the 1960s, Jeep used a unique Dana 44 IFS setup, that was short lived. In the 1980s and 1990s, Ford used a form of IFS known as "Twin Traction Beam" (TTB). This Dana 44 had no axle tubes but attached to the driver side traction beam, which also acted as a cover plate, and had "open air" axles which traveled through the beams to the spindles.

4. Jeep CJ - Wikipedia

   en.wikipedia.org/wiki/Jeep_CJ

   1979 Jeep CJ Silver Anniversary edition, lengthened nose as compared to pre-1972 models 1979 Jeep CJ Silver Anniversary edition interior. 1973 Super Jeep; Only produced in 1973, the Super Jeep was an appearance package created because of a shortage of aluminum wheels needed for the CJ-5 Renegade versions. Only a few hundred were built. [71]

5. Jeep four-wheel-drive systems - Wikipedia

   en.wikipedia.org/wiki/Jeep_four-wheel-drive_systems

   The 'N' mode disengages the transfer case, transmission, and engine from the axles, thus enabling flat-towing the Jeep behind another vehicle. In 1983, the NP219-based Quadra-Trac system was replaced by the NP228/229-based Selec-Trac , adding a fuel-saving 2WD mode to the full- and part-time 4WD modes of Quadra-Trac.

6. Jeep Cherokee (XJ) - Wikipedia

   en.wikipedia.org/wiki/Jeep_Cherokee_(XJ)

   Jeep simply used a single axle tube from hub to hub with no differential between, resulting in an inexpensive front suspension. For 1996, partially to comply with new U.S. OBD-II exhaust and evaporative emissions regulations, the engine management system was upgraded to Chrysler's then-new "JTEC" PCM.

7. Willys Jeep Truck - Wikipedia

   en.wikipedia.org/wiki/Willys_Jeep_Truck

   The Jeep Truck was available with only one transmission, the Borg-Warner T-90 three-speed manual, with synchromeshed second and third gears. A Spicer/Dana 18 transfer case was used on four-wheel drive models. The heavy duty Timken 51540 was used in the early years of production, later being replaced by the Dana 53. The front axle was a Dana 25