Search results
Results from the WOW.Com Content Network
In computing, traceroute and tracert are diagnostic command-line interface commands for displaying possible routes (paths) and transit delays of packets across an Internet Protocol (IP) network. The command reports the round-trip times of the packets received from each successive host (remote node) along the route to a destination.
Text mode is a computer display mode in which content is internally represented on a computer screen in terms of characters rather than individual pixels.Typically, the screen consists of a uniform rectangular grid of character cells, each of which contains one of the characters of a character set; at the same time, contrasted to graphics mode or other kinds of computer graphics modes.
A BIOS Color Attribute is an 8 bit value where the low 4 bits represent the character color and the high 4 bits represent the background color. The name comes from the fact that these colors are used in BIOS interrupts, specifically INT 10h, the video interrupt. When writing text to the screen, a BIOS color attribute is used to designate the ...
The traceroute command can be implemented by transmitting IP datagrams with specially set IP TTL header fields, and looking for ICMP time exceeded in transit and destination unreachable messages generated in response. The related ping utility is implemented using the ICMP echo request and echo reply messages.
The advantages of PathPing over ping and traceroute are that each node is pinged as the result of a single command, and that the behavior of nodes is studied over an extended time period, rather than the default ping sample of four messages or default traceroute single route trace. The disadvantage is that it takes a total of 25 seconds per hop ...
Command Prompt, also known as cmd.exe or cmd, is the default command-line interpreter for the OS/2, [1] eComStation, ArcaOS, Microsoft Windows (Windows NT family and Windows CE family), and ReactOS [2] operating systems. On Windows CE .NET 4.2, [3] Windows CE 5.0 [4] and Windows Embedded CE 6.0 [5] it is referred to as the Command Processor ...
This is a private-use code (as indicated by the letter p), using a non-standard extension to include a string-valued parameter. Following the letter of the standard would consider the sequence to end at the letter D. CSI s — This saves the cursor position. Using the sequence CSI u will restore it to the position. Say the current cursor ...
Show which processes are using which sockets (similar to -b under Windows) (you must be root to do this) No No Yes -P protocol: Shows connections for the protocol specified by protocol. In this case, protocol can be ip, ipv6, icmp, icmpv6, igmp, udp, tcp, or rawip. No No Yes -r: Displays the contents of the IP routing table.