Search results
Results from the WOW.Com Content Network
Switching loops can cause misleading entries in a switch's media access control (MAC) database and can cause endless unicast frames to be broadcast throughout the network. A loop can make a switch receive the same broadcast frames on two different ports, and alternatingly associate the sending MAC address with the one or the other port.
A loop-switch sequence [1] (also known as the for-case paradigm [2] or Anti-Duff's Device) is a programming antipattern where a clear set of steps is implemented as a switch-within-a-loop. The loop-switch sequence is a specific derivative of spaghetti code. It is not necessarily an antipattern to use a switch statement within a loop—it is ...
In the C programming language, Duff's device is a way of manually implementing loop unrolling by interleaving two syntactic constructs of C: the do-while loop and a switch statement. Its discovery is credited to Tom Duff in November 1983, when Duff was working for Lucasfilm and used it to speed up a real-time animation program.
Most commonly the cause is a switching loop in the Ethernet network topology (i.e. two or more paths exist between switches). A simple example is both ends of a single Ethernet patch cable connected to a switch.
Unidirectional Link Detection (UDLD) is a data link layer protocol from Cisco Systems to monitor the physical configuration of cables and detect unidirectional links. UDLD complements the Spanning Tree Protocol which is used to eliminate switching loops.
The SLPP protocol checks packets from the originating switch and the peer switch in a SMLT configuration. Sending hello packets on a per VLAN basis allows SLPP to detect VLAN based network loops for un-tagged as well as tagged IEEE 802.1Q VLAN link configurations. If a loop is detected, the associated port is shut down.
The brand also has an earplug, known as Loop Switch, that lets you transition between the three types using a side dial. ... Loop’s highest decibel earplug is the Loop Quiet; ...
Ethernet Ring Protection Switching (ERPS) is an effort at ITU-T under G.8032 Recommendation to provide sub-50ms protection and recovery switching for Ethernet traffic in a ring topology and at the same time ensuring that there are no loops formed at the Ethernet layer.