enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Rubber cement - Wikipedia

   en.wikipedia.org/wiki/Rubber_cement

   Rubber cement (cow gum in British English) is an adhesive made from elastic polymers (typically latex) mixed in a solvent such as acetone, hexane, heptane or toluene to keep it fluid enough to be used. This makes it part of the class of drying adhesives: as the solvents quickly evaporate, the rubber solidifies, forming a strong yet flexible bond.

3. Silicone - Wikipedia

   en.wikipedia.org/wiki/Silicone

   Formerol is a silicone rubber (marketed as Sugru) used as an arts-and-crafts material, as its plasticity allows it to be molded by hand like modeling clay. It hardens at room temperature and it is adhesive to various substances including glass and aluminum. [25] Oogoo is an inexpensive silicone clay, which can be used as a substitute for Sugru ...

4. List of glues - Wikipedia

   en.wikipedia.org/wiki/List_of_glues

   bone glue, and fish glue including isinglass. Animal connective tissue. and bones hides are acid-treated, neutralized, and repeatedly soaked; the soaking-water is dried into chips hydrolyzed collagen: Until it cools Thermoplastic. Somewhat brittle when set Water-soluble Cabinetmaking, bookbinding, lutherie, glue-size: Keratin glues Hoof glue ...

5. Cyanoacrylate - Wikipedia

   en.wikipedia.org/wiki/Cyanoacrylate

   Cyanoacrylate adhesives are sometimes known generically as instant glue, power glue, or super glue. The abbreviation "CA" is commonly used for industrial grade cyanoacrylate. The abbreviation "CA" is commonly used for industrial grade cyanoacrylate.

6. Araldite - Wikipedia

   en.wikipedia.org/wiki/Araldite

   Araldite adhesive is used to join together the two sections of carbon composite which make up the monocoque of the Lamborghini Aventador. The use of Araldite adhesive in architecture to bond thin joints of pre-cast concrete units was pioneered by Ove Arup in Coventry cathedral and the Sydney Opera House. [4]

7. Hot-melt adhesive - Wikipedia

   en.wikipedia.org/wiki/Hot-melt_adhesive

   The bonding temperature is lower than with most other HMAs, only about 50 °C (122 °F) to 70 °C (158 °F), when the adhesive behaves as a soft rubber acting as a pressure-sensitive adhesive. The surface wetting in this amorphous state is good, and on cooling the polymer crystallizes, forming a strong flexible bond with high cohesion.