Search results
Results from the WOW.Com Content Network
Its first product was the "Thor" pneumatic hammer to pound rivets and drill holes for bolts used to fasten the fire box of a locomotive to its boiler. The name "Thor" referred to: Thor, the mythical god of thunder, frequently pictured as wielding a mighty hammer. The name became popular and spread to other company products. [2]
The compound tool differs from progressive and stage tools by the arrangement of the punch and die. It is an inverted tool where blanking and piercing takes place in a single stage and also the blanking punch will act as the piercing die. That means punch will be to the bottom side of the tool and piercing punches to top side of the tool.
A punch is a tool used to indent or create a hole through a hard surface. They usually consist of a hard metal rod with a narrow tip at one end and a broad flat "butt" at the other. When used, the narrower end is pointed against a target surface and the broad end is struck with a hammer or mallet , causing the blunt force of the blow to be ...
Quick change tool system (left: die; front: punch, split punch retainer; back: tool body; right: punch guide) A die set consists of a set of punches and dies which, when pressed together, form a hole in a workpiece (and may also deform the workpiece in some desired manner). The punches and dies are removable, with the punch being attached to ...
A manual impact driver (for use with hammer) with screwdriver bits and adapters. An impact driver is a tool that delivers a strong, sudden rotational force and forward thrust. The force can be delivered either by striking with a hammer in the case of manual impact drivers, or mechanically in the case of powered impact drivers.
Air hammer (fabrication), a pneumatic hand tool used to carve in stone, and to break or cut metal objects apart; Air hammer (pile driver), a pile driver that is driven by air; Jackhammer, a pneumatic or electro-mechanical tool that combines a hammer directly with a chisel; Nail gun, a form of hammer used to drive nails into wood or other materials
The hammer has a hole through its center that the top of the punch sits in, and holds the top of the punch centered. The sliding block has a hole through it that, when reset, is misaligned with the hole through the hammer. When the body is pressed to the trip point, a taper in the body forces the block sideways until the hole in the block is ...
Chassis punches: assorted sizes round and square Chassis punches: assorted sizes round and square disassembled. In metalworking, a knockout punch, also known as a chassis punch, panel punch, Greenlee punch, or a Q-max, [1] is a hand tool used to punch a hole through sheet metal. It is a very simple tool that consists of a punch, die, and screw.