enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Epoxy moisture control system - Wikipedia

   en.wikipedia.org/wiki/Epoxy_moisture_control_system

   Epoxy moisture control systems can be applied over concrete with relative humidity levels up to 100%, and there are systems available on the market today that can be applied over concrete that is physically damp. In some cases, with the use of an epoxy moisture control system, floor coverings can be installed just 7 days after the slab is poured.

3. Damp proofing - Wikipedia

   en.wikipedia.org/wiki/Damp_proofing

   Concrete normally allows moisture to pass through so a vertical vapor barrier is needed. Barriers may be a coating or membrane applied to the exterior of the concrete. The coating may be asphalt, asphalt emulsion, a thinned asphalt called cutback asphalt, or an elastomer. [9] Membranes are rubberized asphalt or EPDM rubber. Rubberized products ...

4. Vapor barrier - Wikipedia

   en.wikipedia.org/wiki/Vapor_barrier

   A slab-on-grade or basement floor should be poured over a cross-laminated polyethylene vapor barrier over 4 inches (10 cm) of granular fill to prevent wicking of moisture from the ground and radon gas incursion. Inside a steel building, water vapor will condense whenever it comes into contact with a surface that is below the dew point temperature.

5. Waterproofing - Wikipedia

   en.wikipedia.org/wiki/Waterproofing

   Walls also have vapor barriers or air barriers. Damp proofing is another aspect of waterproofing. Masonry walls are built with a damp-proof course to prevent rising damp , and the concrete in foundations needs to be damp-proofed or waterproofed with a liquid coating, basement waterproofing membrane (even under the concrete slab floor where ...

6. Concrete sealer - Wikipedia

   en.wikipedia.org/wiki/Concrete_sealer

   Research from major concrete authorities, including the American Concrete Institute, Portland Cement Association, and the National Ready Mixed Concrete Association confirm that most concrete damage is attributable to surface moisture intrusion. [citation needed] The most pervasive form of concrete damage is surface scaling from freeze/thaw.

7. Basement waterproofing - Wikipedia

   en.wikipedia.org/wiki/Basement_waterproofing

   Spalling is a condition where constant high humidity or moisture breaks down masonry surfaces, causing deterioration and shedding of the concrete surfaces. Other coatings can be effective where condensation is the main source of wetness. It is also effective if the problem has minor dampness. Usually, interior waterproofing will not stop major ...

8. Damp (structural) - Wikipedia

   en.wikipedia.org/wiki/Damp_(structural)

   Structural dampness is the presence of unwanted moisture in the structure of a building, either the result of intrusion from outside or condensation from within the structure. A high proportion of damp problems in buildings are caused by ambient climate dependent factors of condensation and rain penetration. [ 1 ]

9. Concrete leveling - Wikipedia

   en.wikipedia.org/wiki/Concrete_leveling

   In civil engineering, concrete leveling is a procedure that attempts to correct an uneven concrete surface by altering the foundation that the surface sits upon. It is a cheaper alternative to having replacement concrete poured and is commonly performed at small businesses and private homes as well as at factories, warehouses, airports and on roads, highways and other infrastructure.