Search results
Results from the WOW.Com Content Network
where is the void ratio, is the porosity, V V is the volume of void-space (gases and liquids), V S is the volume of solids, and V T is the total (or bulk) volume. This figure is relevant in composites, in mining (particular with regard to the properties of tailings), and in soil science.
The tendency for a soil to dilate or contract depends primarily on the confining pressure and the void ratio of the soil. The rate of dilation is high if the confining pressure is small and the void ratio is small. The rate of contraction is high if the confining pressure is large and the void ratio is large.
The compression index C c, which is defined as the change in void ratio per 10-fold increase in consolidation pressure, is in the range of 0.19 to 0.28 for kaolinite, 0.50 to 1.10 for illite, and 1.0 to 2.6 for montmorillonite, for different ionic forms. [7]
An example of lateral earth pressure overturning a retaining wall. The lateral earth pressure is the pressure that soil exerts in the horizontal direction. It is important because it affects the consolidation behavior and strength of the soil and because it is considered in the design of geotechnical engineering structures such as retaining walls, basements, tunnels, deep foundations and ...
where is the equivalent stress, is the pressure, is the pre-consolidation pressure, and is the slope of the critical state line in space. The pre-consolidation pressure evolves as the void ratio ( e {\displaystyle e} ) (and therefore the specific volume v {\displaystyle v} ) of the soil changes.
This phenomenon of soil behaviour can be included in the Hardening Soil model by means of a dilatancy cut-off. In order to specify this behaviour, the initial void ratio, e i n i t {\displaystyle e_{init}} , and the maximum void ratio, e m a x {\displaystyle e_{max}} , of the material must be entered as general parameters.
e is the void ratio; Saturated unit weight The unit weight of a soil when all void spaces of the soil are completely filled with water, with no air. The formula for saturated unit weight is: = (+) + where γ s is the saturated unit weight of the material; γ w is the unit weight of water
If a soil is loaded beyond this point the soil is unable to sustain the increased load and the structure will break down. [4] This breakdown can cause a number of different things depending on the type of soil and its geologic history. Preconsolidation pressure cannot be measured directly, but can be estimated using a number of different ...