Search results
Results from the WOW.Com Content Network
The use of cigarette lighter receptacles to supply 12 volt DC power is an example of backward compatibility to a de facto standard. As a power connector, the lighter receptacle is larger, harder to use and less reliable than other DC connectors [citation needed]. Cigarette lighter receptacles are in widespread use in many highway vehicles and ...
Trickle charging is the process of charging a fully charged battery at a rate equal to its self-discharge rate, enabling the battery to remain at its fully charged level. This state occurs almost exclusively when the battery is not loaded, as trickle charging will not keep a battery charged if current is being drawn by a load.
A residual-current device (RCD), residual-current circuit breaker (RCCB) or ground fault circuit interrupter (GFCI) [a] is an electrical safety device, more specifically a form of Earth-leakage circuit breaker, that interrupts an electrical circuit when the current passing through line and neutral conductors of a circuit is not equal (the term residual relating to the imbalance), therefore ...
A fuse consists of a metal strip or wire fuse element, of small cross-section compared to the circuit conductors, mounted between a pair of electrical terminals, and (usually) enclosed by a non-combustible housing. The fuse is arranged in series to carry all the charge passing through the protected circuit. The resistance of the element ...
Cigarette lighter may refer to: Cigarette lighter receptacle, an in-car electric socket; Lighter, a portable device used to create a flame
In electrical distribution, a fuse cutout or cut-out fuse (often referred to as a cutout) is a combination of a fuse and a switch, used in primary overhead feeder lines and taps to protect distribution transformers from current surges and overloads. An overcurrent caused by a fault in the transformer or customer circuit will cause the fuse to ...
Tripler (left) and doubler (right). The tripler has a red fuse carrier visible. Plug adaptors permit two or more plugs to share one socket-outlet, or allow the use of a plug of different type. There are several common types, including double- and triple-socket blocks, shaver adaptors, and multi-socket strips.
Trickle valves can be used only on systems operating under negative pressure. The vacuum created inside the dust collector holds the valve closed, allowing a head of material to build up above the trickle valve. Once the pressure of the material equals the negative pressure of the system, the valve is forced open and a trickle of material will ...