Search results
Results from the WOW.Com Content Network
The output is usually connected to an external pull-up resistor, which pulls the output voltage to the resistor's supply voltage when the transistor is off. For PNP open collector outputs, the emitter of the PNP transistor is internally connected to the positive voltage rail, so the collector outputs a high voltage when the transistor is on or ...
A Class B push–pull output driver using a pair of complementary PNP and NPN bipolar junction transistors configured as emitter followers. A push–pull amplifier is a type of electronic circuit that uses a pair of active devices that alternately supply current to, or absorb current from, a connected load. This kind of amplifier can enhance ...
All types have a maximum collector current of 100 mA, except that the original Philips tentative data dated 4.4.1966 specified a maximum collector current of 100 mA peak (I CM) for the BC107/8/9, and Telefunken originally specified a maximum collector current of 50 mA for the BC109, but since at least 1973 all have revised collector currents of 100 mA average or 200 mA peak, except that the ...
The 2N3055 is a silicon NPN power transistor intended for general purpose applications. It was introduced in the early 1960s by RCA using a hometaxial power transistor process, transitioned to an epitaxial base in the mid-1970s. [1] Its numbering follows the JEDEC standard. [2] It is a transistor type of enduring popularity. [3] [4] [5]
The output open collector transistor, T11, can sink currents up to 100 mA, and is protected from polarity reversal with a reverse diode. [ 4 ] [ 5 ] The circuit does not provide protection against excessive current or overheating.
The circuit can be explained by viewing the transistor as being under the control of negative feedback. From this viewpoint, a common-collector stage (Fig. 1) is an amplifier with full series negative feedback. In this configuration (Fig. 2 with β = 1), the entire output voltage V out is placed contrary and in series with the input voltage V in.
A common variation omits the collector resistor of the output transistor, making an open-collector output. This allows the designer to fabricate wired logic by connecting the open-collector outputs of several logic gates together and providing a single external pull-up resistor. If any of the logic gates becomes logic low (transistor conducting ...
The output transistor is not allowed to saturate (i.e. its base–collector junction must remain reverse-biased) because the first transistor, when saturated, establishes full (100%) parallel negative feedback between the collector and the base of the second transistor. [3] Since collector–emitter voltage is equal to the sum of its own base ...