Search results
Results from the WOW.Com Content Network
The presence of continuous noise on an idle channel creates a DC voltage which turns the receiver audio off. When a signal with little or no noise is received, the noise-derived voltage is reduced and the receiver audio is unmuted. Noise squelch can be defeated by intermodulation present in the high-pass band. For this reason, many receivers ...
The voltage is stepped down at the destination. Similarly, in a constant-voltage speaker system, the amplifier uses a transformer to step up the voltage of the audio signal to reduce power loss over the speaker cable, allowing more power to be transmitted over a given wire diameter.
Nearly all modern mixing consoles have a switch for turning phantom power on or off; in most high-end equipment this can be done individually by channel, while on smaller mixers a single master switch may control power delivery to all channels. Phantom power can be blocked in any channel with a 1:1 isolation transformer or blocking capacitors.
Noise, static or snow screen captured from a blank VHS tape. Noise, commonly known as static, white noise, static noise, or snow, in analog video, CRTs and television, is a random dot pixel pattern of static displayed when no transmission signal is obtained by the antenna receiver of television sets and other display devices.
The Commercial Advertisement Loudness Mitigation Act (H.R. 1084/S. 2847) (CALM Act) requires the U.S. Federal Communications Commission to bar the audio of TV commercials from being broadcast louder than the TV program material they accompany by requiring all "multichannel video programming" distributors to implement the "Techniques for Establishing and Maintaining Audio Loudness for Digital ...
A switchable power strip or power bar. Timers can be used to turn off standby power to devices that are unused on a regular schedule. Switches that turn the power off when the connected device goes into standby, [30] or that turn other outlets on or off when a device is turned on or off are also available. Switches can be activated by sensors.
Balanced audio connections use a number of techniques to reduce noise. A typical balanced cable contains two identical wires, which are twisted together and then wrapped with a third conductor (foil or braid) that acts as a shield. The two wires form a circuit that can carry an audio signal.
Analogue television systems put about 70% to 90% of the transmitters power into the sync pulses. The remainder of the transmitter's power goes into transmitting the video's higher frequencies and the FM audio carrier. Digital television modulation systems are about 30% more efficient than analogue modulation systems overall.