Search results
Results from the WOW.Com Content Network
Compression Attached Memory Module (CAMM) is a memory module form factor which uses a land grid array, and developed at Dell by engineer Tom Schnell as a replacement for DIMMs and SO-DIMMs which use edge connectors and had been in use for about 25 years. [1] The first SO-DIMMs were introduced by JEDEC in 1997. [2] [3] [4] [5]
Available for Windows 7 to 11, or Windows Server from 2008 R2 to 2022; 32/64-bit x86 or 64-bit ARM. SoftPerfect RAM Disk can access memory available to Windows, i.e. on 32-bit systems it is limited to the same 4 GB as the 32-bit Windows itself, otherwise for physical memory beyond 4 GB it must be installed on 64-bit Windows.
The expansion memory can be provided by a combination of 30-pin SIMM RAM on an internal card, a Commodore 17xx-series REU (or a clone) plugged into the RAM Port, or a GeoRAM. Provides its own copy of JiffyDOS , allowing accelerated operation with any other Jiffy DOS -equipped disk device, as well as shorthand commands ( DOS Wedge ) to ...
Memory scrubbing consists of reading from each computer memory location, correcting bit errors (if any) with an error-correcting code , and writing the corrected data back to the same location. [ 1 ] Due to the high integration density of modern computer memory chips , the individual memory cell structures became small enough to be vulnerable ...
A SO-DIMM (pronounced "so-dimm" / ˈ s oʊ d ɪ m /, also spelled "SODIMM") or small outline DIMM, is a smaller alternative to a DIMM, being roughly half the physical size of a regular DIMM. The first SODIMMs had 72 pins and were introduced by JEDEC in 1997. [8] [9] [10] Before its introduction, many laptops would use proprietary [11] RAM ...
In computing, serial presence detect (SPD) is a standardized way to automatically access information about a memory module.Earlier 72-pin SIMMs included five pins that provided five bits of parallel presence detect (PPD) data, but the 168-pin DIMM standard changed to a serial presence detect to encode more information.
PC133 is a computer memory standard defined by the JEDEC. PC133 refers to SDR SDRAM operating at a clock frequency of 133 MHz, on a 64-bit-wide bus, at a voltage of 3.3 V. PC133 is available in 168-pin DIMM and 144-pin SO-DIMM form factors. PC133 is the fastest and final SDR SDRAM standard ever approved by the JEDEC, and delivers a bandwidth of ...
Memory controller with differential serial connections to DDR2 FB-DIMMs. The AMB is visible in the center of each DIMM. A Fully Buffered DIMM (FB-DIMM) is a type of memory module used in computer systems. It is designed to improve memory performance and capacity by allowing multiple memory modules to be each connected to the memory controller ...