enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. ISO metric screw thread - Wikipedia

   en.wikipedia.org/wiki/ISO_metric_screw_thread

   A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25).

3. Computer case screws - Wikipedia

   en.wikipedia.org/wiki/Computer_case_screws

   7 thumb screw 6-32 × 6 mm for 2.5” drive tray, expansion slots; 4 hexagon screw 6-32 × 6 mm for psu; 21 phillips screw 6-32 × 5 mm for motherboard, 3.5” harddisk tray; 12 phillips screw M3 × 5 mm for 2.5” harddrive; 16 KB5 x 10 mm for fans; 9 standoff 6-32 × 6.5 + 4 mm for motherboard; 1 positioning standoff 6-32 × 6.5 + 4 mm for ...

4. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   Pentalobe screw sizes include TS1 (also known as P2 or 0.8 mm, used on the iPhone 4 and subsequent models), TS4 (also known as P5 or 1.2 mm, used on the MacBook Air [since late 2010], the MacBook Pro with Retina Display and the 2015 MacBook) and TS5 (also known as P6 or 1.5 mm, used on the 2009 MacBook Pro battery).

5. Preferred metric sizes - Wikipedia

   en.wikipedia.org/wiki/Preferred_metric_sizes

   Machine screws with different thread diameters Hex key set with metric sizes from 2 mm to 10 mm according to sizes for use with ISO 262 screw sizes (except 3.5 mm for M6 internal set screw) For each size bolt or screw and type of head, there is a corresponding size driver prescribed by various ISO standards, including:

6. Countersink - Wikipedia

   en.wikipedia.org/wiki/Countersink

   This may be required to allow the correct seating for a countersunk-head screw or to provide the lead in for a second machining operation such as tapping. Countersink cutters are manufactured with six common angles, which are 60°, 82°, 90°, 100°, 110°, or 120°, with the two most common of those being 82° and 90°.

7. List of DIN standards - Wikipedia

   en.wikipedia.org/wiki/List_of_DIN_standards

   Slotted countersunk head screws (with countersunk heads as specified in ISO 2009-1972) Withdrawn: DIN EN ISO 2009: ISO 2009: DIN 964: Slotted raised countersunk oval head screws: Withdrawn: DIN EN ISO 2010: ISO 2010: DIN 965: Cross recessed countersunk flat head screws: Withdrawn: DIN EN ISO 7046-1, DIN EN ISO 7046-2: ISO 7046-1, ISO 7046-2 ...