Ads
related to: hexagon nut with flange hole in back end of bolt cutter ebay
Search results
Results from the WOW.Com Content Network
A split beam nut, also known as a split hex nut [1] or slotted beam nut, [2] is a locknut with slots cut in the top that separate the outside end into two [3] or more sections that are bent slightly inward, making the thread diameter undersized in the slotted portion.
Hanger bolt - Bolt that has no head, machine threaded body followed by a wood threaded screw tip. Allow nuts to be attached to what is really a screw. Hex bolt - Bolt with a hexagonal head and threaded shank. Section immediately under head may be unthreaded for fastening thicker materials. J bolt - Bolt shaped like the letter J, used for tie downs.
A self-aligning nut, also known as a spherical nut [2] or leveling nut, is a type of nut used in applications where the fastener is not perpendicular to the surface to which the nut anchors. A flange nut is used inside a specially shaped dished-out washer. The device is commonly used in the aerospace industry.
Acorn nut (cap nut) Crown hex nut, blind nut, cap nut, domed cap nut, or dome nut A nut that has a domed end on one side Barrel nut: Steel cross dowel or dowel nut, cross dowel (woodworking) A round slug or formed sheet metal part with threads perpendicular to the length of the nut Cage nut: Caged nut, captive nut, clip nut
A counterbore hole is typically used when a fastener, such as a socket head cap screw or fillister head screw, is required to sit flush with or below the level of a workpiece's surface. Whereas a counterbore is a flat-bottomed enlargement of a smaller coaxial hole, a countersink is a conical enlargement of such.
A back countersink, also known as an inserted countersink, is a two piece countersink used on tough to reach areas. One component is a rod that is inserted into the existing hole in the workpieces; the other component is the cutter, which is attached to the rod, or extends out of it, after it is in position. [3]
The bolt has one or two holes drilled through its threaded end. The nut is torqued properly and then, if the slot is not aligned with the hole in the fastener, the nut is rotated forward to the nearest slot. The nut is then secured with a split pin/cotter pin, R-clip or safety wire. It is a positive locking device. [1]
Some nuts do not attach to the workpiece. These are usually shaped as either a rectangle, a flange nut, or a hex nut; the rectangular speed nut is also known as a flat-style speed nut. Speed nuts that attach to the workpiece usually are some form of a J-nut or U-nut. [2] [3]
Ads
related to: hexagon nut with flange hole in back end of bolt cutter ebay