enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Nut (hardware) - Wikipedia

   en.wikipedia.org/wiki/Nut_(hardware)

   Acorn nut (cap nut) Crown hex nut, blind nut, cap nut, domed cap nut, or dome nut A nut that has a domed end on one side Barrel nut: Steel cross dowel or dowel nut, cross dowel (woodworking) A round slug or formed sheet metal part with threads perpendicular to the length of the nut Cage nut: Caged nut, captive nut, clip nut

3. Split beam nut - Wikipedia

   en.wikipedia.org/wiki/Split_beam_nut

   A split beam nut, also known as a split hex nut [1] or slotted beam nut, [2] is a locknut with slots cut in the top that separate the outside end into two [3] or more sections that are bent slightly inward, making the thread diameter undersized in the slotted portion.

4. Flange nut - Wikipedia

   en.wikipedia.org/wiki/Flange_nut

   A self-aligning nut, also known as a spherical nut [2] or leveling nut, is a type of nut used in applications where the fastener is not perpendicular to the surface to which the nut anchors. A flange nut is used inside a specially shaped dished-out washer. The device is commonly used in the aerospace industry.

5. Bolt (fastener) - Wikipedia

   en.wikipedia.org/wiki/Bolt_(fastener)

   Hanger bolt - Bolt that has no head, machine threaded body followed by a wood threaded screw tip. Allow nuts to be attached to what is really a screw. Hex bolt - Bolt with a hexagonal head and threaded shank. Section immediately under head may be unthreaded for fastening thicker materials. J bolt - Bolt shaped like the letter J, used for tie downs.

6. Computer case screws - Wikipedia

   en.wikipedia.org/wiki/Computer_case_screws

   The bolt end is typically hex-shaped, but may exceptionally be round to make removal more difficult. The hex diameter is 3/16", or 4.7mm. A 5mm hex socket might still fit, however where tightening or removal is required, care needs to be taken to select a nut driver with a sufficiently small outer diameter, as clearance between the jackpost and ...

7. Counterbore - Wikipedia

   en.wikipedia.org/wiki/Counterbore

   A counterbore hole is typically used when a fastener, such as a socket head cap screw or fillister head screw, is required to sit flush with or below the level of a workpiece's surface. Whereas a counterbore is a flat-bottomed enlargement of a smaller coaxial hole, a countersink is a conical enlargement of such.