Ad
related to: simple power supply diagramQuail.com has been visited by 10K+ users in the past month
Search results
Results from the WOW.Com Content Network
Entry-Level Power Supply Specification (EPS) is a power supply unit meant for high-power-consumption computers and entry-level servers. Developed by the Server System Infrastructure (SSI) forum, a group of companies including Intel, Dell, Hewlett-Packard and others, that works on server standards, the EPS form factor is a derivative of the ATX ...
A simple general-purpose desktop power supply used in electronic labs, with power output connector seen at lower-left and power input connector (not shown) located at the rear Interior of high-end linear power supply with toroidal mains transformer. A power supply is an electrical device that supplies electric power to an electrical load.
A typical one-line diagram with annotated power flows. Red boxes represent circuit breakers, grey lines represent three-phase bus and interconnecting conductors, the orange circle represents an electric generator, the green spiral is an inductor, and the three overlapping blue circles represent a double-wound transformer with a tertiary winding.
In contrast, a linear power supply regulates the output voltage by continually dissipating power in the pass transistor. The switched-mode power supply's higher electrical efficiency is an important advantage. Switched-mode power supplies can also be substantially smaller and lighter than a linear supply because the transformer can be much smaller.
You are free: to share – to copy, distribute and transmit the work; to remix – to adapt the work; Under the following conditions: attribution – You must give appropriate credit, provide a link to the license, and indicate if changes were made.
A circuit diagram (or: wiring diagram, electrical diagram, elementary diagram, electronic schematic) is a graphical representation of an electrical circuit. A pictorial circuit diagram uses simple images of components, while a schematic diagram shows the components and interconnections of the circuit using standardized symbolic representations.
This is a critical point – each power supply must be able to power the entire server by itself. Redundancy is further enhanced by plugging each power supply into a different circuit (i.e. to a different circuit breaker). Redundant protection can be extended further yet by connecting each power supply to its own UPS.
One-line diagrams represent the three or four conductors of three-phase power circuits with one line. Wiring diagrams are sometimes made. These show and name the termination points and names of each conductor. In some systems, enough information can be put onto the schematics so that wiring diagrams are not needed.
Ad
related to: simple power supply diagramQuail.com has been visited by 10K+ users in the past month