Search results
Results from the WOW.Com Content Network
The remainder of the Vendor Specific Data Block is the "data payload", which can be anything the vendor considers worthy of inclusion in this EDID extension block. For example, IEEE registration number 00 0C 03 means this is a "HDMI Licensing, LLC" specific data block (contains HDMI 1.4 info), C4 5D D8 means this is a "HDMI Forum" specific data ...
0x0A Serial number data block provides product serial number as an ASCII string. 0x0B General-purpose ASCII string block provides general purpose text strings that may be required by specific applications. 0xD0 Interface power sequencing block defines display interface signal timings required for entering and exiting sleep mode.
It specifies a means for a computer to send commands to the monitor, as well as receive sensor data from the monitor, over a bidirectional link. Specific commands to control monitors are defined in a separate Monitor Control Command Set (MCCS) standard version 1.0, released in September 1998.
It is possible to select the input source using a VCP command. Some monitors will only take VCP commands from the active input source, others will take commands from any connected input source. Three categories of controls exist: Continuous (C) Allow values between zero and a maximum value. Non-continuous (NC) Only support a limited set of values.
cmd.exe in Windows NT 2000, 4DOS, 4OS2, 4NT, and a number of third-party solutions allow direct entry of environment variables from the command prompt. From at least Windows 2000, the set command allows for the evaluation of strings into variables, thus providing inter alia a means of performing integer arithmetic.
Drive: This command-line argument specifies the drive letter of the disk for which to display the volume label and serial number. Note: On Windows, the volume serial number is displayed only for disks formatted with MS-DOS version 4.0 or later. OS/2 allows the user to specify more than one drive. The vol command displays the volume labels ...
The first version of the MIPI DSI, version 1.0 was released in 2005. MIPI DSI v1.1 was released in 2007, and added features such as "Command Mode" for directly sending commands and data to display modules using the display controller. [1] DSI v1.2 was released in 2011, and extended the video packet length and expanded the command mode. [2]
In computing, serial presence detect (SPD) is a standardized way to automatically access information about a memory module. Earlier 72-pin SIMMs included five pins that provided five bits of parallel presence detect (PPD) data, but the 168-pin DIMM standard changed to a serial presence detect to encode more information.