Search results
Results from the WOW.Com Content Network
If an adapter is operating in normal mode, it will drop this frame, and the IP stack never sees or responds to it. If the adapter is in promiscuous mode, the frame will be passed on, and the IP stack on the machine (to which a MAC address has no meaning) will respond as it would to any other ping. [6]
Xerox Network Systems (XNS) Mail. Despite this port being assigned by IANA, the service is meant to work on SPP (ancestor of IPX/SPX), instead of TCP/IP. [36] 61: Reserved: Historically assigned to the NIFTP-Based Mail protocol, [38] but was never documented in the related IEN. [39] The port number entry was removed from IANA's registry on 2017 ...
802.11 networks in infrastructure mode are half-duplex; all stations share the medium. In infrastructure or access point mode, all traffic has to pass through an Access Point (AP). Thus, two stations on the same access point that are communicating with each other must have each and every frame transmitted twice: from the sender to the access ...
In computer networking, a port or port number is a number assigned to uniquely identify a connection endpoint and to direct data to a specific service. At the software level, within an operating system , a port is a logical construct that identifies a specific process or a type of network service .
A network interface controller (NIC, also known as a network interface card, [3] network adapter, LAN adapter and physical network interface [4]) is a computer hardware component that connects a computer to a computer network. [5] Early network interface controllers were commonly implemented on expansion cards that plugged into a computer bus.
The port will not send out DTP frames or be affected by any incoming DTP frames. If you want to set a trunk between two switches when DTP is disabled, you must manually configure trunking using the (switchport mode trunk) command on both sides. The configured switch port mode setting is referred to as the port's trunking administrative mode.
A bypass switch (or bypass TAP) is a hardware device that provides a fail-safe access port for an in-line active security appliance such as an intrusion prevention system (IPS), next generation firewall (NGFW), etc. Active, in-line security appliances are single points of failure in live computer networks because if the appliance loses power, experiences a software failure, or is taken off ...
The bridge has three ports. A is connected to bridge port 1, B is connected to bridge port 2, C is connected to bridge port 3. A sends a frame addressed to B to the bridge. The bridge examines the source address of the frame and creates an address and port number entry for host A in its forwarding table. The bridge examines the destination ...