Search results
Results from the WOW.Com Content Network
The four mounting holes in a Mini-ITX board line up with four of the holes in ATX-specification motherboards, and the locations of the backplate and expansion slot are the same [2] (though one of the holes used was optional in earlier versions of the ATX spec). Mini-ITX boards can therefore often be used in cases designed for ATX, micro-ATX and ...
Proprietary Mini-ITX variant i.a. for more than two memory slots, designed for chassis with support for Micro-ATX size and above Mini-STX: Intel: 2015 147 × 140 mm (5.79 × 5.51 in) Smaller than Mini-ITX, but bigger than the NUC, this board is used in small form factor computers, using a socketed intel core processor and SO-DIMMS.
Comparison of the form factors for motherboards ATX, μATX (micro-ATX), DTX, mini-ITX and mini-DTX The DTX form factor is a variation of ATX specification [1] designed especially for small form factor PCs (especially for HTPCs) with dimensions of 8 × 9.6 inches (203 × 244 mm). [2]
Comparison BTX μBTX nanoBTX ITX picoBTX BTX case of a Fujitsu Siemens Esprimo P2510 Clearly visible: the four holes for the "Support and Retention Module (SRM)". BTX (for Balanced Technology eXtended) is a form factor for motherboards, originally intended to be the replacement for the aging ATX motherboard form factor in late 2004 and early 2005.
FlexATX is a motherboard form factor derived from ATX.The specification was released in 1999 by Intel as an addendum to the microATX specification. It uses a subset of the motherboard mounting holes required for microATX and the same I/O plate system as ATX and microATX.
As electronic hardware has become smaller following Moore's law and related patterns, ever-smaller form factors have become feasible. Specific technological advances, such as PCI Express, have had a significant design impact, though form factors have historically evolved slower than individual components.
Baby AT motherboard An ATX Form Card, used by later Baby-AT motherboards to allow for USB, PS/2 mouse, and IR connectivity through headers. In 1987, the Baby AT form factor was introduced, based on the motherboard found in the IBM PC/XT 286 (5162) [2] and soon after all computer makers abandoned AT for the cheaper and smaller Baby AT form factor, using it for computers that spanned several ...
PC/104(-Plus) or Mini PCI are often added for expansion on small form factor boards such as Mini-ITX. For their 1000 EX and 1000 HX models, Tandy Computer designed the PLUS expansion interface, an adaptation of the XT-bus supporting cards of a smaller form factor. Because it is electrically compatible with the XT bus (a.k.a. 8-bit ISA or XT-ISA ...