Search results
Results from the WOW.Com Content Network
The Corrected d-exponent, also known as dc-exponent or cd-exponent, is a parameter used in mud logging and formation pore pressure analysis in the petroleum industry. It is an extrapolation of certain drilling parameters to estimate a pressure gradient for pore pressure evaluation while drilling, particularly in over-pressured zones.
In the oil industry, mud weight is the density of the drilling fluid and is normally measured in pounds per gallon (lb/gal) (ppg) or pound cubic feet (pcf) . [1] In the field it is measured using a mud scale or mud balance. Mud can weigh up to 22 or 23 ppg. A gallon of water typically weighs 8.33 pounds (or 7.48 ppg).
The (quart) Marsh funnel time for typical drilling muds is 34 to 50 seconds, though mud mixtures to cope with some geological conditions may have a time of 100 or more seconds. [ 3 ] While the most common use is for drilling muds , which are non-Newtonian fluids , the Marsh funnel is not a rheometer , because it only provides one measurement ...
When underbalanced drilling is used, mud pulse telemetry can become unusable. This is usually because, in order to reduce the equivalent density of the drilling mud, a compressible gas is injected into the mud. This causes high signal attenuation which drastically reduces the ability of the mud to transmit pulsed data. In this case, it is ...
In geotechnical engineering, drilling fluid, also known as drilling mud, is used to aid the drilling of boreholes into the earth. Used while drilling oil and natural gas wells and on exploration drilling rigs , drilling fluids are also used for much simpler boreholes, such as water wells .
Drilling Formula Sheets is a set of Drilling Formulas used commonly by drilling engineers in the onshore and offshore oil drilling industry. They are used as part of a key piece of engineering work called Well Control .
Mud is a vital part of drilling operations. It provides hydrostatic pressure on the borehole wall to prevent uncontrolled production of reservoir fluids, lubricates and cools the drill bit, carries the drill cuttings up to the surface, forms a "filter-cake" on the borehole wall to prevent drilling fluid invasion, provides an information medium for well logging, and helps the drilling by ...
Using the figures above, we can calculate the maximum pressure at various depths in an offshore oil well. Saltwater is 0.444 psi/ft (2.5% higher than fresh water but this not general and depends on salt concentration in water) Pore pressure in the rock could be as high as 1.0 psi/ft of depth (19.25 lb/gal)