Search results
Results from the WOW.Com Content Network
The (quart) Marsh funnel time for typical drilling muds is 34 to 50 seconds, though mud mixtures to cope with some geological conditions may have a time of 100 or more seconds. [ 3 ] While the most common use is for drilling muds , which are non-Newtonian fluids , the Marsh funnel is not a rheometer , because it only provides one measurement ...
In the oil industry, mud weight is the density of the drilling fluid and is normally measured in pounds per gallon (lb/gal) (ppg) or pound cubic feet (pcf) . [1] In the field it is measured using a mud scale or mud balance. Mud can weigh up to 22 or 23 ppg. A gallon of water typically weighs 8.33 pounds (or 7.48 ppg).
The Corrected d-exponent, also known as dc-exponent or cd-exponent, is a parameter used in mud logging and formation pore pressure analysis in the petroleum industry. It is an extrapolation of certain drilling parameters to estimate a pressure gradient for pore pressure evaluation while drilling, particularly in over-pressured zones.
Measurement while drilling can be cost-effective in exploration wells, particularly in areas of the Gulf of Mexico where wells are drilled in areas of salt diapirs. The resistivity log will detect penetration into salt, and early detection prevents salt damage to bentonite drilling mud. [citation needed]
In geotechnical engineering, drilling fluid, also known as drilling mud, is used to aid the drilling of boreholes into the earth. Used while drilling oil and natural gas wells and on exploration drilling rigs , drilling fluids are also used for much simpler boreholes, such as water wells .
Drilling Formula Sheets is a set of Drilling Formulas used commonly by drilling engineers in the onshore and offshore oil drilling industry. They are used as part of a key piece of engineering work called Well Control .
During drilling, kicks are usually killed using the Driller's, Engineer's or a hybrid method called Concurrent, while forward circulating. The choice will depend on: the amount and type of kick fluids in the well; the rig's equipment capabilities; the minimum fracture pressure in the open hole; the drilling and operating companies well control ...
Using the figures above, we can calculate the maximum pressure at various depths in an offshore oil well. Saltwater is 0.444 psi/ft (2.5% higher than fresh water but this not general and depends on salt concentration in water) Pore pressure in the rock could be as high as 1.0 psi/ft of depth (19.25 lb/gal)