enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Belt (mechanical) - Wikipedia

   en.wikipedia.org/wiki/Belt_(mechanical)

   12.7 mm = 0.5 inch width, 38° pulley angle imperial belts B: 17 mm: 11 mm: 40° 16.5 mm = 21/32 inch width, 38° angle imperial belts C: 22 mm: 14 mm: 40° 22.2 mm = 7/8 inch width, 38° angle imperial belts D: 32 mm: 19 mm: 40° 31.75 mm = 1.25 inch width, 38° angle imperial belts E: 38 mm: 25 mm: 40° 38.1 mm = 1.5 inch width, 38° angle ...

3. Pulley - Wikipedia

   en.wikipedia.org/wiki/Pulley

   A pulley is a wheel on an axle or shaft enabling a taut cable or belt passing over the wheel to move and change direction, or transfer power between itself and a shaft. A sheave or pulley wheel is a pulley using an axle supported by a frame or shell ( block ) to guide a cable or exert force.

4. Key (engineering) - Wikipedia

   en.wikipedia.org/wiki/Key_(engineering)

   For a key to function, the shaft and rotating machine element must have a keyway and a keyseat, which is a slot and pocket in which the key fits. The whole system is called a keyed joint. [1] [2] A keyed joint may allow relative axial movement between the parts. Commonly keyed components include gears, pulleys, couplings, and washers.

5. Line shaft - Wikipedia

   en.wikipedia.org/wiki/Line_shaft

   The fixed pulley on the upper shaft is driven at constant speed by a belt from the power source. The loose pulley ('idler') allows the machine to be stopped in isolation – necessary for changing speed. The stepped pulleys (left) provide three drive speeds for the machine tool (not shown), depending on which pair of pulleys is connected by the ...

6. Drum motor - Wikipedia

   en.wikipedia.org/wiki/Drum_motor

   The shaft can be a single “through” shaft where the motor and gearbox are assembled on, and fixed to, the shaft with keys or pins. However, this type of drum motor design has a limited maximum radial load due to the bending stresses caused by the normal belt tension of a conveyor and is therefore used mainly for small light duty conveyors ...

7. Differential pulley - Wikipedia

   en.wikipedia.org/wiki/Differential_pulley

   The differential pulley was invented in 1854 by Thomas Aldridge Weston from King's Norton, England. [2] The pulleys were manufactured in collaboration with Richard and George Tangye. According to Richard Tangye's autobiography, the Weston differential pulley evolved from the Chinese windlass, with an endless chain replacing the finite length of ...