Search results
Results from the WOW.Com Content Network
Pressure head is a component of hydraulic head, in which it is combined with elevation head. When considering dynamic (flowing) systems, there is a third term needed: velocity head . Thus, the three terms of velocity head , elevation head , and pressure head appear in the head equation derived from the Bernoulli equation for incompressible fluids :
A pressure of 1 bar is slightly less than the current average atmospheric pressure on Earth at sea level (approximately 1.013 bar). [1] [2] By the barometric formula, 1 bar is roughly the atmospheric pressure on Earth at an altitude of 111 metres at 15 °C.
In fluid dynamics, dynamic pressure (denoted by q or Q and sometimes called velocity pressure) is the quantity defined by: [1] = where (in SI units): q is the dynamic pressure in pascals (i.e., kg/(m*s 2), ρ (Greek letter rho) is the fluid mass density (e.g. in kg/m 3), and; u is the flow speed in m/s.
If an NPSH A is say 10 bar then the pump you are using will deliver exactly 10 bar more over the entire operational curve of a pump than its listed operational curve. Example: A pump with a max. pressure head of 8 bar (80 metres) will actually run at 18 bar if the NPSH A is 10 bar. i.e.: 8 bar (pump curve) plus 10 bar NPSH A = 18 bar.
In fluid dynamics, total dynamic head (TDH) is the work to be done by a pump, per unit weight, per unit volume of fluid. TDH is the total amount of system pressure, measured in feet, where water can flow through a system before gravity takes over, and is essential for pump specification.
This is the reciprocal of 1.013250—the conversion factor from atmospheres to bars. [1] Specifically in the hydrology domain, permeability of soil or rock may also be defined as the flux of water under hydrostatic pressure (≈ 0.1 bar/m) at a temperature of 20 °C. In this specific setup, 1 darcy is equivalent to 0.831 m/day. [5]
The SI unit for pressure is the pascal (Pa), equal to one newton per square metre (N/m 2, or kg·m −1 ·s −2). This name for the unit was added in 1971; [6] before that, pressure in SI was expressed in newtons per square metre. Other units of pressure, such as pounds per square inch (lbf/in 2) and bar, are also in common use.
1 J·m 3 /mol 2 = 1 m 6 ·Pa/mol 2 = 10 L 2 ·bar/mol 2. 1 L 2 atm/mol 2 = 0.101325 J·m 3 /mol 2 = 0.101325 Pa·m 6 /mol 2. 1 dm 3 /mol = 1 L/mol = 1 m 3 /kmol = 0.001 m 3 /mol (where kmol is kilomoles = 1000 moles)