Search results
Results from the WOW.Com Content Network
Channel your inner MacGyver and discover six ways to open a can without a can opener with our step-by-step guide. Skip to main content. Sign in. Mail. 24/7 Help. For premium support please call: ...
The post How to Open a Can Without a Can Opener appeared first on Reader's Digest. Try these handy methods that incorporate common tools around your home (plus a little elbow grease).
You can open a can without a can opener — you just have to be careful. Here's how to open a can with a knife, metal spoon or no tools at all (a rough surface). Yes, you can open a can without a ...
Safe-crackers can use what are known as jam shots to blow off the safe's doors. Most modern safes are fitted with 'relockers' (like the one described above) which are triggered by excessive force and will then lock the safe semi-permanently (a safe whose relocker has tripped must then be forced, as the combination or key alone will no longer ...
] The can opener is pocket-sized, approximately 1.5 inches (38 mm) long, and consists of a short metal blade that serves as a handle, with a small, hinged metal tooth that folds out to pierce the can lid. A notch just under the hinge point keeps the opener hooked around the rim of the can as the device is "walked" around to cut the lid out.
The P-38 can opener is keychain-sized, about 1.5 inches (38 mm) long, and consists of a short metal blade that serves as a handle (and can also be used as a screwdriver), with a small, hinged metal tooth that folds out to pierce the can lid. A notch just under the hinge point keeps the opener hooked around the rim of the can as the device is ...
Here's how to open a can with a knife or even a spoon and some brute force. And if you happen to be out camping and don't even have that, a rock will suffice.
Wood will expand and contract across the grain, and a wide panel made of solid wood could change width by a half of an inch, warping the door frame. By allowing the wood panel to float, it can expand and contract without damaging the door. A typical panel would be cut to allow 1/4" (5 mm) between itself and the bottom of the groove in the frame.