Search results
Results from the WOW.Com Content Network
where RL(dB) is the return loss in dB, P i is the incident power and P r is the reflected power. Return loss is related to both standing wave ratio (SWR) and reflection coefficient (Γ). Increasing return loss corresponds to lower SWR. Return loss is a measure of how well devices or lines are matched. A match is good if the return loss is high.
Voltage standing wave ratio (VSWR) (pronounced "vizwar" [1] [2]) is the ratio of maximum to minimum voltage on a transmission line . For example, a VSWR of 1.2 means a peak voltage 1.2 times the minimum voltage along that line, if the line is at least one half wavelength long.
Examples of estimated bandwidth of different antennas according to the schedule VSWR and return loss by the help of the ANSYS HFSS [1]. Ansys HFSS (high-frequency structure simulator) is a commercial finite element method solver for electromagnetic (EM) structures from Ansys.
The voltage standing wave ratio (VSWR) at a port, represented by the lower case 's', is a similar measure of port match to return loss but is a scalar linear quantity, the ratio of the standing wave maximum voltage to the standing wave minimum voltage.
The insertion loss is not such a problem for an unequal split of power: for instance -40 dB at port 3 has an insertion loss less than 0.2 dB at port 2. Isolation can be improved at the expense of insertion loss at both output ports by replacing the output resistors with T pads. The isolation improvement is greater than the insertion loss added ...
Perhaps over 30% of all antenna papers submitted to the Transactions in the past twelve months have used return loss incorrectly. The reason for this is uncertain. To remind everyone of the correct terminology, I review the definition of return loss, briefly outline the history of the term, and give some examples of current misuse. </quote>
An affidavit previously obtained by the local news stations stated that Jacob left his girlfriend's house, saying he was going to have dinner with his family.
In real systems, relatively little loss is due to mismatch loss and is often on the order of 1dB [dubious – discuss]. According to Walter Maxwell [2] mismatch does not result in any loss ("wasted" signal), except through the transmission line. This is because the signal reflected from the load is transmitted back to the source, where it is re ...