enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Floor cleaning - Wikipedia

   en.wikipedia.org/wiki/Floor_cleaning

   For a polyurethane coated floor, dampen a mop with water and a few drops of dishwashing liquid. Be sure to ring out the mop thoroughly before using it on the floor. Run the mop back and forth, going with the grain of the wood in smooth strokes. Do not use water for lacquered or shellacked floors, as it can stain the wood and cause buckling.

3. Simple Ways to Remove Candle Wax from Just About Every ...

   www.aol.com/lifestyle/simple-ways-remove-candle...

   One more helpful tip: Whether you’re trying to remove wax or simply doing some regular cleaning, never use these 13 products on your wood floors. What you’ll need. Ice. Dry towel. Spoon or ...

4. Spray foam - Wikipedia

   en.wikipedia.org/wiki/Spray_foam

   Spray foam insulation or spray polyurethane foam (SPF) is an alternative to traditional building insulation such as fiberglass. A two-component mixture composed of isocyanate and polyol resin comes together at the tip of a gun, and forms an expanding foam that is sprayed onto roof tiles, concrete slabs, into wall cavities, or through holes ...

5. Wood finishing - Wikipedia

   en.wikipedia.org/wiki/Wood_finishing

   The bleaches used to remove unwanted fungal stains from wood include two-part peroxide bleach and solutions of sodium hypochlorite. [27] The former is particularly effective at removing the natural colour of wood before it is recoloured with pigmented stains or dyes. [27] Oxalic acid is particularly effective at removing iron stains from wood. [27]

6. Lost-foam casting - Wikipedia

   en.wikipedia.org/wiki/Lost-foam_casting

   Lost-foam casting (LFC) is a type of evaporative-pattern casting process that is similar to investment casting except foam is used for the pattern instead of wax. This process takes advantage of the low boiling point of polymer foams to simplify the investment casting process by removing the need to melt the wax out of the mold.

7. Defoamer - Wikipedia

   en.wikipedia.org/wiki/Defoamer

   The easiest is looking at the surface foam. All that is needed is a system for generating foam. This might be done with a round pumping system with a nozzle and a cylinder or an air injection system into a cylinder. The cylinder is fitted with a scale to measure the foam height. This equipment may have a heater to control the temperature.