Search results
Results from the WOW.Com Content Network
Controls for the reclosers range from the original electromechanical systems to digital electronics with metering and SCADA functions. The ratings of reclosers run from 2.4–38 kV for load currents from 10–1200 A and fault currents from 1–16 kA. [7] [8] On a 3-phase circuit, a recloser is more beneficial than three separate fuse cutouts.
During the start-up a typical rotor has 3 poles connected to the slip ring. Each pole is wired in series with a variable power resistor. When the motor reaches full speed the rotor poles are switched to short circuit. During start-up the resistors reduce the field strength at the stator. As a result, the inrush current is reduced. Another ...
The starter motor is a series, compound, or permanent magnet type electric motor with a solenoid and solenoid operated switch mounted on it. When low-current power from the starting battery is applied to the starter solenoid, usually through a key-operated switch, the solenoid closes high-current contacts for the starter motor and it starts to ...
If you have a trailer with a lot of lights the diode and relay wiring is preferred, but if you have a trailer with a simple light arrangement it is usually sufficient to wire to 58L. In market there are many special converters [ 1 ] [ 2 ] [ 3 ] that solves the problem of connecting a car with European wiring to a trailer with North American wiring.
The Mack MC/MR series, also known as the "Cruise-Hauler", is a cabover truck first introduced in 1978. [1] It is of a distinct "set back front axle" design (first seen on the Mack FM), with the driver compartment mounted ahead of the front axle and with a large, flat, divided windscreen covering almost half of the truck's frontal aspect.
Copper wire in typical hairpin geometry Hairpin technology is a winding technology for stators in electric motors and generators and is also used for traction applications in electric vehicles . In contrast to conventional winding technologies , the hairpin technology is based on solid, flat copper bars which are inserted into the stator stack.
A Dahlander motor (also known as a pole changing motor, dual- or two speed-motor) is a type of multispeed three-phase induction motor, in which the speed of the motor is varied by altering the number of poles; this is achieved by altering the wiring connections inside the motor.
Parts of it look flaky, for instance "Reclosers address this problem by further dividing up the network into smaller sections" where no prior mention has been made of a network or of dividing it. Perhaps just sloppy writing, but "For instance, the city grid example above might be equipped with reclosers" implies that there's an example above ...