Search results
Results from the WOW.Com Content Network
The reactor is a sodium-cooled fast reactor, which uses liquid sodium as the coolant. [4] It uses two separate sodium loops, and these are connected to a main water-cooled loop which feeds the steam generators and turbines for producing electricity. [7] The sodium coolant is pressurized to 5.5 MPa, and is heated to over 500 °C in the reactor. [6]
A fast-neutron reactor (FNR) or fast-spectrum reactor or simply a fast reactor is a category of nuclear reactor in which the fission chain reaction is sustained by fast neutrons (carrying energies above 1 MeV, on average), as opposed to slow thermal neutrons used in thermal-neutron reactors. Such a fast reactor needs no neutron moderator, but ...
1943 Reactor diagram using boron control rods. Control rods are inserted into the core of a nuclear reactor and adjusted in order to control the rate of the nuclear chain reaction and, thereby, the thermal power output of the reactor, the rate of steam production, and the electrical power output of the power station.
For "thermal" (slow-neutron) fission reactors, the typical prompt neutron lifetime is on the order of 10 −4 seconds, and for fast fission reactors, the prompt neutron lifetime is on the order of 10 −7 seconds. [16] These extremely short lifetimes mean that in 1 second, 10,000 to 10,000,000 neutron lifetimes can pass.
The mere fact that an assembly is supercritical does not guarantee that it contains any free neutrons at all. At least one neutron is required to "strike" a chain reaction, and if the spontaneous fission rate is sufficiently low it may take a long time (in 235 U reactors, as long as many minutes) before a chance neutron encounter starts a chain reaction even if the reactor is supercritical.
Pool type sodium-cooled fast reactor (SFR) A sodium-cooled fast reactor is a fast neutron reactor cooled by liquid sodium.. The initials SFR in particular refer to two Generation IV reactor proposals, one based on existing liquid metal cooled reactor (LMFR) technology using mixed oxide fuel (MOX), and one based on the metal-fueled integral fast reactor.
, fast reactors could use all of them for fuel. All actinides can undergo neutron induced fission with unmoderated or fast neutrons. A fast reactor is therefore more efficient than a thermal reactor for using plutonium and higher actinides as fuel. These fast reactors are better suited for the transmutation of other actinides than thermal ...
The chance is dependent on the nuclide as well as neutron energy. For low and medium-energy neutrons, the neutron capture cross sections for fission (σ F), the cross section for neutron capture with emission of a gamma ray (σ γ), and the percentage of non-fissions are in the table at right. Fertile nuclides in nuclear fuels include: