Search results
Results from the WOW.Com Content Network
The test is carried out using a metal mould in the shape of a conical frustum known as a slump cone or Abrams cone, that is open at both ends and has attached handles.The tool typically has an internal diameter of 100 millimetres (3.9 in) at the top and of 200 millimetres (7.9 in) at the bottom with a height of 305 millimetres (12.0 in).The cone is placed on a hard non-absorbent surface.
Flow table with a grip and a hinge, 70 centimetres (28 in) square. In the American version of this test, the table is 10 inches (25 cm) diameter per ASTM C 230.; Abrams cone, open at the top and at the bottom - 30 centimetres (12 in) high, 17 centimetres (6.7 in) top diameter, 25 centimetres (9.8 in) base diameter.
1 Code of practice for the provision of water stops. IS 12200 – 1987 2 Procedure for Testing Parts of IS 8543-19 3 Standard Test Methods for Tensile Properties of Plastics. ASTM : D 638-1991 4 Standard Test Methods for Thermoplastic Elastomers-Tension. ASTM : D 412-1992 (H) HYSD BARS; 1 Specifications for HYSD bars. IS 1786 – 1985
Test methods for the water-cement ratio and fineness modulus). 1919 – Effect of Curing Condition on Wear and Strength of Concrete (Describing 120 tests on cylinder-shaped samples and 300 tests on cubic samples in various moisture conditions and testing periods varying from 3 days to 4 months).
A Marsh funnel is a Marsh cone with a particular orifice and a working volume of 1.5 litres. It consists of a cone 6 inches (152 mm) across and 12 inches in height (305 mm) to the apex of which is fixed a tube 2 inches (50.8 mm) long and 3/16 inch (4.76 mm) internal diameter. A 10-mesh screen is fixed near the top across half the cone. [2]
ISO 4259-4:2021 Part 4: Use of statistical control charts to validate 'in-statistical-control' status for the execution of a standard test method in a single laboratory ISO 4260:1987 Petroleum products and hydrocarbons — Determination of sulfur content — Wickbold combustion method [Withdrawn without replacement]
Workability can be measured by the concrete slump test, a simple measure of the plasticity of a fresh batch of concrete following the ASTM C 143 or EN 12350-2 test standards. Slump is normally measured by filling an "Abrams cone" with a sample from a fresh batch of concrete. The cone is placed with the wide end down onto a level, non-absorptive ...
The cone penetration or cone penetrometer test (CPT) is a method used to determine the geotechnical engineering properties of soils and delineating soil stratigraphy. It was initially developed in the 1950s at the Dutch Laboratory for Soil Mechanics in Delft to investigate soft soils.