Search results
Results from the WOW.Com Content Network
The Whisper family was developed as a line of accurate, multi-purpose cartridges using relatively heavy rifle bullets for a given caliber in subsonic loads. [1] [2] [3] The intention was to create an extremely accurate cartridge family for military, police, competition and specialized hunting markets that could also be easily sound suppressed.
Subsonic ammunition is ammunition designed to operate at velocities below the speed of sound (Mach 1), which at standard conditions is 340.29 m/s (1,116.4 ft/s). This avoids the supersonic shockwave or "crack" of a supersonic bullet, which, particularly for suppressed firearms, influences the loudness of the shot.
Components of a modern bottleneck rifle cartridge. Top-to-bottom: Copper-jacketed bullet, smokeless powder granules, rimless brass case, Boxer primer.. Handloading, or reloading, is the practice of making firearm cartridges by manually assembling the individual components (metallic/polymer case, primer, propellant and projectile), rather than purchasing mass-assembled, factory-loaded ...
The .308 Winchester has a 3.64 mL (56 gr H 2 O) cartridge case capacity. [9] The exterior shape of the case was designed to promote reliable case feeding and extraction in bolt-action rifles and machine guns alike, under extreme conditions. .308 Winchester maximum C.I.P. cartridge dimensions. All dimensions in millimeters (mm) and inches.
The DSR-1 Subsonic is a variant optimized for 7.62×51mm NATO/.308 Winchester subsonic ammunition usage. The barrel length is reduced to 310 mm. The barrel length is reduced to 310 mm. The 8 inch twist rate of the barrel is especially adapted to stabilize the long heavy projectiles used in subsonic ammunition.
The .277 Wolverine will never replace larger high-power cartridges such as the .308 Winchester (7.62×51mm NATO) or .270 Winchester for long range shooting; however – it outperforms the .223 Remington at typical hunting ranges and approaches the 6.8 SPC while using less expensive components (brass, magazines, bolt, less powder per load).
7.62mm Thumper is a barrel specification optimized to run larger bullets out of standard 7.62×39mm cases. [1] Barrels are cut to a standard 7.62×39mm "Russian" chamber but the bore ideally uses a faster 1:8" rifling twist rate in order to stabilize bullets heavier than 200gr at subsonic speeds. [2]
To manufacture cases for cartridges, a sheet of brass is punched into disks. These disks go through a series of drawing dies. The disks are annealed and washed before moving to the next series of dies. The brass needs to be annealed to remove the work-hardening in the material and make the brass malleable again ready for the next series of dies ...