Search results
Results from the WOW.Com Content Network
Also the converse is true: The decimal expansion of a rational number is either finite, or endlessly repeating. Finite decimal representations can also be seen as a special case of infinite repeating decimal representations. For example, 36 ⁄ 25 = 1.44 = 1.4400000...; the endlessly repeated sequence is the one-digit sequence "0".
In order to convert a rational number represented as a fraction into decimal form, one may use long division. For example, consider the rational number 5 / 74 : 0.0 675 74 ) 5.00000 4.44 560 518 420 370 500 etc. Observe that at each step we have a remainder; the successive remainders displayed above are 56, 42, 50.
Metrication in Australia effectively began in 1966 with the conversion to decimal currency under the auspices of the Decimal Currency Board. [1] The conversion of measurements—metrication—commenced subsequently in 1971, under the direction of the Metric Conversion Board and actively proceeded until the Board was disbanded in 1981.
A tape measure or measuring tape is a long, flexible ruler used to measure length or distance. [1] It usually consists of a ribbon of cloth, plastic, fibreglass, or metal strip with linear measurement markings.
Subdivisions of an inch are typically written using dyadic fractions with odd number numerators; for example, two and three-eighths of an inch would be written as 2 + 3 / 8 ″ and not as 2.375″ nor as 2 + 6 / 16 ″. However, for engineering purposes fractions are commonly given to three or four places of decimals and have been ...
k is a decimal digit and R is a fraction that must be converted to decimal. It usually has only a single digit in the numerator, and one or two digits in the denominator, so the conversion to decimal can be done mentally. Example: find the square root of 75. 75 = 75 × 10 2 · 0, so a is 75 and n is 0.
Thus, it is often useful to convert repeating decimals into fractions. A conventional way to indicate a repeating decimal is to place a bar (known as a vinculum) over the digits that repeat, for example 0. 789 = 0.789789789... For repeating patterns that begin immediately after the decimal point, the result of the conversion is the fraction ...
In the SI system and generally in older metric systems, multiples and fractions of a unit can be described via a prefix on a unit name that implies a decimal (base-10), multiplicative factor. The only exceptions are for the SI-accepted units of time (minute and hour) and angle (degree, arcminute, arcsecond) which, based on ancient convention ...