Search results
Results from the WOW.Com Content Network
Electronic controllers add greater flexibility in management of boost pressures, compared with the manual controllers. [2] The actuation of an electronic boost controller can be managed by one of two control systems: Open-loop is the simpler option, where control output is merely based on other inputs such as throttle angle and/or engine speed ...
In an internal combustion engine, a turbocharger (also known as a turbo or a turbosupercharger) is a forced induction device that is powered by the flow of exhaust gases. It uses this energy to compress the intake air, forcing more air into the engine in order to produce more power for a given displacement .
If the aspect ratio is too large, the turbo will fail to create boost at low speeds; if the aspect ratio is too small, the turbo will choke the engine at high speeds, leading to high exhaust manifold pressures, high pumping losses, and ultimately lower power output. By altering the geometry of the turbine housing as the engine accelerates, the ...
The first version of this engine family was a normally aspirated 2.2 L (134 cu in) unit. Developed under the leadership of Chief Engineer – Engine Design and Development Willem Weertman and head of performance tuning Charles "Pete" Hagenbuch, who had worked on most of Chrysler's V-8 engines and the Chrysler Slant-6 engine, [1] it was introduced in the 1981 Dodge Aries, Dodge Omni, Plymouth ...
A mechanically driven supercharger offers exceptional response and low-rpm performance, as it does not rely on pressurization of the exhaust manifold (assuming that it is a positive-displacement design, such as a Roots-type or twin-screw, as opposed to a centrifugal supercharger, which does not provide substantial boost in the lower rpm range), but is less efficient than a turbocharger due to ...
A wastegate is a valve that controls the flow of exhaust gases to the turbine wheel in a turbocharged engine system. [1]Diversion of exhaust gases regulates the turbine speed, which in turn regulates the rotating speed of the compressor.
1973: The next mass-produced turbocharged car was the BMW 2002 Turbo, introduced at the 1973 Frankfurt motor show and featuring a 2.0 L (120 cu in) four-cylinder engine. [10] Due to excessive turbo lag, safety concerns and the 1973/1974 oil crisis, the 2002 Turbo was discontinued in 1974. [10]
It is a development of the IDI Mazda 2.2L normally aspirated, later 2.5L NA and Turbo and later 2.9L NA, with Bosch common-rail direct injection and a variable geometry turbocharger. The WLC engine code is a Mazda engine code, not being changed for use in the Mazda B-Series clone Ford Ranger.