Search results
Results from the WOW.Com Content Network
A rotary cutter is a tool generally used by quilters to cut fabric.It consists of a handle with a circular blade that rotates, thus the tool's name. Rotary cutter blades are very sharp, can be resharpened, and are available in different sizes: usually smaller blades are used to cut small curves, while larger blades are used to cut to straight lines and broad curves.
The original Cricut machine has cutting mats of 150 mm × 300 mm (6 in × 12 in), the larger Cricut Explore allows mats of 300 mm × 300 mm, and 300 mm × 610 mm (12 in × 12 in, and 12 in × 24 in). The largest machine will produce letters from a 13 to 597 mm (0.5 to 23.5 in) high.
These requirements are fulfilled by a doctor blade assembly which includes a doctor blade holder. Doctor blades are traditionally designed in 3 main tip configurations: straight, bevel and lamella. A straight doctor blade has a straight, blunt edge and is used for lower quality print. A beveled doctor blade is cut at an angle creating a beveled ...
A rolling ruler is a ruler that contains a cylinder much like a rolling pin inside, thereby enabling it to "roll" along a sheet of paper or other surface where it is being used. A rolling ruler can draw straight, parallel lines, and also has other instruments included, enabling it to do the jobs of a protractor and compass .
Paper cutters were developed and patented in 1844 by French inventor Guillaume Massiquot. Later, Milton Bradley patented his own version of the paper cutter in 1879. [1] Since the middle of the 19th century, considerable improvements to the paper cutter have been made by Fomm and Krause of Germany, Furnival in England, and Oswego and Seybold in the United States.
Parts of a modern sai. Monouchi, the metal main prong of the sai, that is either round or faceted.; Saki, the sharp point of the main prong. [6]Yoku, the two shorter metal side prongs of the sai, which usually point in the same direction as the main prong, with the exception of the manji sai developed by Taira Shinken, which has the direction of one of the side prongs reversed, causing the ...
Each fuse holder typically has an attached pull ring that can be engaged by a hook at the end of a fiberglass hot stick operated by a lineworker standing on the ground or from a bucket truck, to manually open the switch. While often used for switching, the standard cutout shown is not designed to be manually opened under load.
A planer is a type of metalworking machine tool that uses linear relative motion between the workpiece and a single-point cutting tool to cut the work piece. [1] A planer is similar to a shaper , but larger, and with workpiece moving, whereas in a shaper the cutting tool moves.