Search results
Results from the WOW.Com Content Network
Large industrial condensate pumps may also serve as the feedwater pump. In either case, to force the water into the boiler, the pump must generate sufficient pressure to overcome the steam pressure developed by the boiler. This is usually accomplished through the use of a centrifugal pump.
In fluid dynamics, total dynamic head (TDH) is the work to be done by a pump, per unit weight, per unit volume of fluid.TDH is the total amount of system pressure, measured in feet, where water can flow through a system before gravity takes over, and is essential for pump specification.
Self-priming pumps have to be capable of evacuating air from the pump suction line without any external auxiliary devices. Centrifugal pumps with an internal suction stage such as water-jet pumps or side-channel pumps are also classified as self-priming pumps. [10] Self-Priming centrifugal pumps were invented in 1935.
In industry, circulator pumps are used in processes, plant maintenance, and as built-in parts in Original Equipment Manufacturer (OEM) products. In the water-supply and wastewater sector, Grundfos offers pumps for irrigation, green houses and for municipal, private and industrial water supply as well as for sewage applications.
Submersible pump cables are electrical conductors designed for use in wet ground or under water, with types specialized for pump environmental conditions. [5] [6] [7] A submersible pump cable is a specialized product to be used for a submersible pump in a deep well, or in similarly harsh conditions.
The device uses the water hammer effect to develop pressure that lifts a portion of the input water that powers the pump to a point higher than where the water started. The hydraulic ram is sometimes used in remote areas, where there is both a source of low-head hydropower, and a need for pumping water to a destination higher in elevation than ...
A chain pump is a type of water pump that uses a chain to move water from one place to another. It works on the principle of a continuous loop of chain moving through a series of sprockets, with attached buckets that lift water as the chain passes over the top sprocket and discharge it as the chain reaches the bottom.
An axial-flow pump for industrial use. An axial-flow pump, or AFP, is a common type of pump that essentially consists of a propeller (an axial impeller) in a pipe.The propeller can be driven directly by a sealed motor in the pipe or by electric motor or petrol/diesel engines mounted to the pipe from the outside or by a right-angle drive shaft that pierces the pipe.